CHM2179a
Typical Bias and IF Configuration
W-band Mixer
Several external configurations are possible for bias and IF. The objective is to give
flexibility for the integration.
As this component is mainly dedicated to low IF use, there are several possibilities for
interfacing with low noise IF amplifier. The optimum IF load for conversion loss is 200Ω,
however depending on the IF amplifier noise characteristic this load can be modified in order
to optimise the noise figure. A series capacitor, between IF output and the load is
recommended.
Due to high sensitivity to electrical discharges a integrated resistance is used and two ports
are available for biasing. One is for the connection of a decoupling capacitor (C_ext) and the
other one is for the supply voltage connection through an external series resistance (+V
port). However, in order to keep the compatibility with the CHM2179, only the “C_ext” port
can be used.
+V
C_bias
R_bias1
+V
1k
R_load_IF
+V
R_load_IF
C_IF
IF
C_bias
R_bias2
C_IF
C_ext
C_ext
+V
1k
IF
LO
RF
LO
RF
Recommended external bias and
IFconfiguration
Other possible configuration
(compatible with the previous version)
The recommended values for external components are:
C_bias
R_bias1
R_bias2
R_load_IF
R_bias*C >> 1/F_IF
2.9kΩ for 1mA current consumption (V = 4.5V, typical LO
power)
R_bias2 = R_bias1 + 1kΩ
From 50 to 200Ω
Notes::
1. R_bias = R_bias1 + 1kΩ when “+V” port is used, otherwize R_bias = R_bias2
2. R_bias can be adjusted if necessary; This allows to optimise the performances when
some parameters are different from recommended ones (Supply voltage, LO power …).
However maximum ratings for the current have to be taken into account.
3. A series capacitor at IF outputs is recommended for DC decoupling.
Ref. : DSCH21790192 - 22-Jun-00
4/6
Specifications subject to change without notice
Route Départementale 128 , B.P.46 - 91401 ORSAY Cedex - FRANCE
Tel.: +33 (0)1 69 33 03 08 - Fax : +33 (0)1 69 33 03 09
UMS [ UNITED MONOLITHIC SEMICONDUCTORS ]
