Tr i path Technol ogy, I nc. -
Technical Information
ABSOLUTE MAXIMUM RATINGS
SYMBOL
V
DD5
V
SS5
V
DD15
V
SS15
T
J
T
A
T
STORE
T
SOLDER
I
OUT
V
IN
V
CMR
Positive 5V Supply Voltage
Negative 5V Supply Voltage
Positive 15V Supply Voltage
Negative 15V Supply Voltage
Maximum Junction Temperature
Operating Free-air Temperature Range
Storage Temperature Range
Manual soldering for three seconds
Reflow soldering for five seconds
Output current limit, OUTP or OUTN
Input voltage, INP or INN
Common mode input voltage range
PARAMETER
Value
+6
-6
+ 18
- 18
150
-40 to +85
-55 to 150
350
245
1.1
V
SS5
to V
DD5
V
SS5
to V
DD5
UNITS
V
V
V
V
ºC
ºC
ºC
ºC
A
V
V
Notes:
1.
Absolute Maximum Ratings indicate limits beyond which damage to the device may occur.
2.
The absolute value of VDD5 and VSS5 must always be less than or equal to the absolute value of VDD15 and
VSS15.
3.
The TLD4012 incorporates an exposed die pad on the underside of its package. This acts as a heat sink
and must be connected to a copper plane on the printed circuit board for proper heat dissipation.
Failure to do so may result in exceeding the maximum junction temperature which could permanently
damage the device. This copper plane must be connected to VSS15. See the Application Information
section of this document for additional information.
4.
Application must insure that VSS15 is applied before VSS5. A clamp diode connected between VSS5 and
VSS15 can be used to insure proper application of supply voltages to the TLD4012 (see Test/Application
Circuits of this document). Note that only one diode is needed per board for multi-channel line cards, but diode
selection should account for the increased current transient that the diode must carry for multiple channels. If
the +/-5V rail’s rise time is fast, for example in applications in which the driver’s supplies might be hot-plugged,
this method may not be sufficient and supply sequencing may be necessary.
RECOMMENDED OPERATING CONDITIONS
SYMBOL
V
DD5
V
SS5
V
DD15
V
SS15
V
IH
V
IL
I
ODLEAK
I
ODMAX
Positive 5V Supply Voltage
Negative 5V Supply Voltage
Positive 15V Supply Voltage
Negative 15V Supply Voltage
High-level Input Voltage, all digital inputs
Low-level Input Voltage, all digital inputs
Open drain leakage current, FAULT output
Open drain sink current at V
OL
=0.4V max, FAULT output
1
PARAMETER
MIN.
+ 4.75
- 5.25
+ 13.3
- 15.75
2.7
0
TYP.
+5
-5
+ 15
- 15
MAX.
+ 5.25
- 4.75
+ 15.75
- 13.3
+V
DD5
0.8
1
UNITS
V
V
V
V
V
V
µA
mA
Note: Recommended Operating Conditions indicate conditions for which the device is functional. See Electrical
Characteristics for guaranteed specific performance limits.
3
TLD4012 – JB/Rev. 2.0a/05.02
TRIPATH [ TRIPATH TECHNOLOGY INC. ]
