欢迎访问ic37.com |
会员登录 免费注册
发布采购

TS8GCF600 参数 Datasheet PDF下载

TS8GCF600图片预览
型号: TS8GCF600
PDF下载: 下载PDF文件 查看货源
内容描述: 600X CF卡 [600X CompactFlash Card]
分类和应用:
文件页数/大小: 87 页 / 2726 K
品牌: TRANSCEND [ TRANSCEND INFORMATION. INC. ]
 浏览型号TS8GCF600的Datasheet PDF文件第5页浏览型号TS8GCF600的Datasheet PDF文件第6页浏览型号TS8GCF600的Datasheet PDF文件第7页浏览型号TS8GCF600的Datasheet PDF文件第8页浏览型号TS8GCF600的Datasheet PDF文件第10页浏览型号TS8GCF600的Datasheet PDF文件第11页浏览型号TS8GCF600的Datasheet PDF文件第12页浏览型号TS8GCF600的Datasheet PDF文件第13页  
TS8G~32GCF600
TS8G~32GCF600
Signal Description
Signal Name
A10 – A00
(PC Card Memory Mode)
600X CompactFlash Card
Dir.
I
Pin
Description
8,10,11,12, These address lines along with the -REG signal are used to select the following:
14,15,16,17, The I/O port address registers within the CompactFlash Storage Card , the
memory mapped port address registers within the CompactFlash Storage Card,
18,19,20
a byte in the card's information structure and its configuration control and status
registers.
This signal is the same as the PC Card Memory Mode signal.
A10 – A00
(PC Card I/O Mode)
A02 - A00
(True IDE Mode)
I
18,19,20
In True IDE Mode, only A[02:00] are used to select the one of eight registers
in the Task File, the remaining address lines should be grounded by the
host.
This signal is asserted high, as BVD1 is not supported.
BVD1
(PC Card Memory Mode)
I/O
46
-STSCHG
(PC Card I/O Mode)
Status Changed
This signal is asserted low to alert the host to changes in the READY and Write
Protect states, while the I/O interface is configured. Its use is controlled by the
Card Config and Status Register.
In the True IDE Mode, this input / output is the Pass Diagnostic signal in the
Master / Slave handshake protocol.
-PDIAG
(True IDE Mode)
BVD2
(PC Card Memory Mode)
I/O
45
This signal is asserted high, as BVD2 is not supported.
-SPKR
(PC Card I/O Mode)
This line is the Binary Audio output from the card. If the Card does not support
the Binary Audio function, this line should be held negated.
In the True IDE Mode, this input/output is the Disk Active/Slave Present signal in
the Master/Slave handshake protocol.
-DASP
(True IDE Mode)
-CD1, -CD2
(PC Card Memory Mode)
O
26,25
These Card Detect pins are connected to ground on the CompactFlash Storage
Card. They are used by the host to determine that the CompactFlash Storage
Card is fully inserted into its socket.
This signal is the same for all modes.
-CD1, -CD2
(PC Card I/O Mode)
-CD1, -CD2
(True IDE Mode)
This signal is the same for all modes.
Transcend Information Inc.
9
V1.0