TS8G~32GCF600
600X CompactFlash Card
Signal Name
Dir.
Pin
Description
This signal is used during Memory Cycles to distinguish between Common
Memory and Register (Attribute) Memory accesses. High for Common Memory,
Low for Attribute Memory.
-REG
I
44
(PC Card Memory Mode– Except
Ultra DMA Protocol Active)
Attribute Memory Select
In PC Card Memory Mode, when Ultra DMA Protocol is supported by the host
and the host has enabled Ultra DMA protocol on the card the, host shall keep the
-REG signal negated during the execution of any DMA Command by the device.
The signal shall also be active (low) during I/O Cycles when the I/O address is on
the Bus.
-REG
(PC Card I/O Mode –Except Ultra
DMA Protocol Active)
In PC Card I/O Mode, when Ultra DMA Protocol is supported by the host and the
host has enabled Ultra DMA protocol on the card the, host shall keep the -REG
signal asserted during the execution of any DMA Command by the device.
This is a DMA Acknowledge signal that is asserted by the host in response to
(-)DMARQ to initiate DMA transfers.
-DMACK
(PC Card Memory Mode when
Ultra DMA Protocol Active)
In True IDE Mode, while DMA operations are not active, the card shall ignore the
(-)DMACK signal, including a floating condition.
DMACK
(PC Card I/O Mode when Ultra
DMA Protocol Active)
If DMA operation is not supported by a True IDE Mode only host, this signal
should be driven high or connected to VCC by the host.
-DMACK
(True IDE Mode)
A host that does not support DMA mode and implements both PC Card and
True-IDE modes of operation need not alter the PC Card mode connections
while in True-IDE mode as long as this does not prevent proper operation all
modes.
RESET
I
41
The CompactFlash Storage Card is Reset when the RESET pin is high with the
following important exception:
(PC Card Memory Mode)
The host may leave the RESET pin open or keep it continually high from the
application of power without causing a continuous Reset of the card. Under
either of these conditions, the card shall emerge from power-up having
completed an initial Reset.
The CompactFlash Storage Card is also Reset when the Soft Reset bit in the
Card Configuration Option Register is set.
RESET
This signal is the same as the PC Card Memory Mode signal.
(PC Card I/O Mode)
In the True IDE Mode, this input pin is the active low hardware reset from the
host.
-RESET
(True IDE Mode)
VCC
--
13,38
+5 V, +3.3 V power.
(PC Card Memory Mode)
VCC
This signal is the same for all modes.
This signal is the same for all modes.
(PC Card I/O Mode)
VCC
(True IDE Mode)
Transcend Information Inc.
13
V1.0
TRANSCEND [ TRANSCEND INFORMATION. INC. ]
