TSA7887
DESCRIPTION OF OPERATION
The TSA7887 is
single/dual-channel,
a
single-supply, low-power,
12-bit successive-
analog input on one side and REF on the other, the
analog signal is acquired. During the acquisition
phase, the inputs to the comparator are balanced
since both inputs are connected to REF.
approximation ADC with an easy-to-use serial
interface. The ADC can be operated from a 3V
supply (2.7V to 3.6V) or from a 5V supply (4.75V to
5.25V). When operated from either a 3V or 5V
supply, the TSA7887 can operate at throughput
rates up to 125ksps when an external 2 MHz clock is
applied.
During the conversion phase as shown in the
equivalent circuit in Figure 2, Switch SW1 is moved
from Position A to GND at Position B and Switch
SW2 is opened. At this point in time, the inputs to
In 8-pin SOIC and MSOP packages, the TSA7887
integrates
a
2.5-V reference,
a
high-speed
track/hold, a successive-approximation ADC, and a
serial digital interface. An external serial clock is
used to transfer data to/from the ADC and controls
the TSA7887’s conversion process. The TSA7887
can be configured for single- or two-channel
operation. When configured as a single-channel
ADC, the analog input range is 0 to VREF (where an
externally applied VREF, if used, can range between
1.2 V and VDD). When the TSA7887 is configured
for two-channel applications, the analog input range
on each channel is set internally from 0V to VDD.
Figure 2: TSA7887’s Conversion Phase Equivalent
Circuit
the
comparator
become
unbalanced.
The
TSA7887’s control logic and the charge-
redistribution DAC work together to add or subtract
fixed packets of charge from the sampling capacitor
to balance once again the comparator input
terminals. At the time when the comparator is
rebalanced, the conversion process is complete and
the ADC’s control logic generates the ADC serial
output conversion data.
If the TSA7887 is configured for single-channel
operation, the TSA7887 can be operated in a read-
only mode by applying a logic LOW at all times to
the DIN pin (Pin 6) or by hard-wiring the DIN pin
permanently to GND. For maximum flexibility to
address multiple configurations based on the
application, the DIN input can be used to load ADC
configuration data from a host processor into the
TSA7887’s 8-bit Control Register.
Figure 3 illustrates the ideal transfer function for the
TSA7887 where the output data is coded straight
binary. Thus, the designed code transitions occur at
successive integer LSB values (that is, at 1 LSB, at
2 LSBs, etc) where the LSB size is VREF/4096.
TSA7887 Operation and Transfer Function
The TSA7887 is a successive-approximation ADC,
the core of which is a charge-redistribution DAC.
Figure 1 illustrates an equivalent circuit for the
TSA7887 in signal acquisition phase. Here, Switch
SW1 is in Position A and Switch SW2 is closed. With
the sampling capacitor’s terminals connected to the
Figure 1:TSA7887’s Acquisition Phase Equivalent
Figure 3: TSA7887’s Unipolar Transfer Function for
Circuit
Straight Binary Digital Data.
TSA7887DS r1p0
Page 9
RTFDS
TOUCHSTONE [ TOUCHSTONE SEMICONDUCTOR INC ]
