TMS320F28335, TMS320F28334, TMS320F28332
TMS320F28235, TMS320F28234, TMS320F28232
www.ti.com
SPRS439I–JUNE 2007–REVISED MARCH 2011
6.10 Enhanced Control Peripherals
6.10.1 Enhanced Pulse Width Modulator (ePWM) Timing
PWM refers to PWM outputs on ePWM1–6. Table 6-20 shows the PWM timing requirements and
Table 6-21, switching characteristics.
Table 6-20. ePWM Timing Requirements(1)
TEST CONDITIONS
Asynchronous
MIN
2tc(SCO)
MAX
UNIT
cycles
cycles
cycles
tw(SYCIN)
Sync input pulse width
Synchronous
2tc(SCO)
With input qualifier
1tc(SCO) + tw(IQSW)
(1) For an explanation of the input qualifier parameters, see Table 6-13.
Table 6-21. ePWM Switching Characteristics
PARAMETER
TEST CONDITIONS
MIN
20
MAX
UNIT
ns
tw(PWM)
Pulse duration, PWMx output high/low
Sync output pulse width
tw(SYNCOUT)
td(PWM)tza
8tc(SCO)
cycles
ns
Delay time, trip input active to PWM forced high
Delay time, trip input active to PWM forced low
no pin load
25
20
td(TZ-PWM)HZ
Delay time, trip input active to PWM Hi-Z
ns
6.10.2 Trip-Zone Input Timing
(A)
XCLKOUT
t
w(TZ)
TZ
t
d(TZ-PWM)HZ
(B)
PWM
A. TZ - TZ1, TZ2, TZ3, TZ4, TZ5, TZ6
B. PWM refers to all the PWM pins in the device. The state of the PWM pins after TZ is taken high depends on the PWM
recovery software.
Figure 6-15. PWM Hi-Z Characteristics
Table 6-22. Trip-Zone Input Timing Requirements(1)
MIN
1tc(SCO)
MAX UNIT
cycles
tw(TZ)
Pulse duration, TZx input low
Asynchronous
Synchronous
2tc(SCO)
cycles
With input qualifier
1tc(SCO) + tw(IQSW)
cycles
(1) For an explanation of the input qualifier parameters, see Table 6-13.
Copyright © 2007–2011, Texas Instruments Incorporated
Electrical Specifications
139
Submit Documentation Feedback
Product Folder Link(s): TMS320F28335 TMS320F28334 TMS320F28332 TMS320F28235 TMS320F28234
TMS320F28232
TI [ TEXAS INSTRUMENTS ]
