TMS320F28335, TMS320F28334, TMS320F28332
TMS320F28235, TMS320F28234, TMS320F28232
Digital Signal Controllers (DSCs)
www.ti.com
SPRS439C–JUNE 2007–REVISED FEBRUARY 2008
6.6 Timing Parameter Symbology
Timing parameter symbols used are created in accordance with JEDEC Standard 100. To shorten the
symbols, some of the pin names and other related terminology have been abbreviated as follows:
Lowercase subscripts and their
meanings:
Letters and symbols and their
meanings:
a
c
d
f
access time
cycle time (period)
delay time
H
L
High
Low
V
X
Z
Valid
fall time
Unknown, changing, or don't care level
High impedance
h
r
hold time
rise time
su
t
setup time
transition time
valid time
v
w
pulse duration (width)
6.6.1 General Notes on Timing Parameters
All output signals from the 28x devices (including XCLKOUT) are derived from an internal clock such that
all output transitions for a given half-cycle occur with a minimum of skewing relative to each other.
The signal combinations shown in the following timing diagrams may not necessarily represent actual
cycles. For actual cycle examples, see the appropriate cycle description section of this document.
6.6.2 Test Load Circuit
This test load circuit is used to measure all switching characteristics provided in this document.
Tester Pin Electronics
Data Sheet Timing Reference Point
Output
Under
Test
42 Ω
3.5 nH
Transmission Line
(Α)
Z0 = 50 Ω
(B)
Device Pin
4.0 pF
1.85 pF
A. Input requirements in this data sheet are tested with an input slew rate of < 4 Volts per nanosecond (4 V/ns) at the
device pin.
B. The data sheet provides timing at the device pin. For output timing analysis, the tester pin electronics and its
transmission line effects must be taken into account. A transmission line with a delay of 2 ns or longer can be used to
produce the desired transmission line effect. The transmission line is intended as a load only. It is not necessary to
add or subtract the transmission line delay (2 ns or longer) from the data sheet timing.
Figure 6-4. 3.3-V Test Load Circuit
6.6.3 Device Clock Table
This section provides the timing requirements and switching characteristics for the various clock options
available. Table 6-4 and Table 6-5 list the cycle times of various clocks.
116
Electrical Specifications
Submit Documentation Feedback
TI [ TEXAS INSTRUMENTS ]
