TMS320F2809, TMS320F2808, TMS320F2806
TMS320F2802, TMS320F2801, UCD9501
TMS320C2802, TMS320C2801, and TMS320F2801x DSPs
www.ti.com
SPRS230H–OCTOBER 2003–REVISED JUNE 2006
Table 6-2. TMS320F2806 Current Consumption by Power-Supply Pins at 100-MHz SYSCLKOUT
(1)
(2)
(3)
IDD
IDDIO
TYP(4)
IDD3VFL
IDDA18
TYP(4)
IDDA33
TYP(4)
MAX
MODE
TEST CONDITIONS
TYP(4)
MAX
MAX
TYP(4)
MAX
MAX
The following peripheral
clocks are enabled:
•
•
•
•
•
•
•
•
ePWM1/2/3/4/5/6
eCAP1/2/3/4
eQEP1/2
eCAN-A
SCI-A/B
SPI-A
ADC
I2C
Operational
(Flash)
195 mA
230 mA
15 mA
27 mA
35 mA
40 mA
30 mA
38 mA
1.5 mA
2 mA
All PWM pins are toggled at
100 kHz.
All I/O pins are left
unconnected.
Data is continuously
transmitted out of the
SCI-A, SCI-B, and eCAN-A
ports. The hardware
multiplier is exercised.
Code is running out of flash
with 3 wait-states.
XCLKOUT is turned off
Flash is powered down.
XCLKOUT is turned off.
The following peripheral
clocks are enabled:
IDLE
75 mA
90 mA
12 mA
500 µA
2 mA
2 µA
10 µA
5 µA
50 µA
15 µA
30 µA
•
•
•
•
eCAN-A
SCI-A
SPI-A
I2C
Flash is powered down.
Peripheral clocks are off.
STANDBY
HALT
6 mA
100 µA
60 µA
500 µA
120 µA
2 µA
2 µA
10 µA
10 µA
5 µA
5 µA
50 µA
50 µA
15 µA
15 µA
30 µA
30 µA
Flash is powered down.
Peripheral clocks are off.
Input clock is disabled.
70 µA
(1) IDDIO current is dependent on the electrical loading on the I/O pins.
(2) IDDA18 includes current into VDD1A18 and VDD2A18 pins. In order to realize the IDDA18 currents shown for IDLE, STANDBY, and HALT,
clock to the ADC module must be turned off explicitly by writing to the PCLKCR0 register.
(3) IDDA33 includes current into VDDA2 and VDDAIO pins.
(4) The TYP numbers are applicable over room temperature and nominal voltage.
NOTE
The peripheral - I/O multiplexing implemented in the 280x devices prevents all available
peripherals from being used at the same time. This is because more than one peripheral
function may share an I/O pin. It is, however, possible to turn on the clocks to all the
peripherals at the same time, although such a configuration is not useful. If this is done,
the current drawn by the device will be more than the numbers specified in the current
consumption tables.
90
Electrical Specifications