MECHANICAL DATA
MPDS105 – AUGUST 2001
DVA (R-PDSO-G8/28)
PLASTIC SMALL-OUTLINE
C
A
18,10
17,70
0,25 M B M
28
15
B
7,60
7,40
10,65
10,01
D
Index
Area
1
14
2,65
2,35
0,75
0,25
x 45°
C
Seating
Plane
0,10
0,32
0,23
0,51
0,33
1,27
0,30
0,10
G
0,25
M C A M B S
0°–8°
1,27
0,40
F
4202103/B 08/01
NOTES: A. All linear dimensions are in millimeters.
G. Lead width, as measured 0,36 mm or greater
above the seating plane, shall not exceed a
maximum value of 0,61 mm.
H. Lead-to-lead coplanarity shall be less than
0,10 mm from seating plane.
B. This drawing is subject to change without notice.
C. Body length dimension does not include mold
flash, protrusions, or gate burrs. Mold flash, protrusions,
and gate burrs shall not exceed 0,15 mm per side.
D. Body width dimension does not include inter-lead flash
or portrusions. Inter-lead flash and protrusions
shall not exceed 0,25 mm per side.
I. Falls within JEDEC MS-013-AE with the exception
of the number of leads.
E. The chamfer on the body is optional. If it is not present,
a visual index feature must be located within the
cross-hatched area.
F. Lead dimension is the length of terminal for soldering
to a substrate.
1
POST OFFICE BOX 655303 • DALLAS, TEXAS 75265
TI [ TEXAS INSTRUMENTS ]
