MECHANICAL DATA
MPDI058 – APRIL 2001
NVA (R-PDIP-T7/14)
PLASTIC DUAL-IN-LINE
D
0.775 (19,69)
0.735 (18,67)
14
8
0.280 (7,11)
0.240 (6,10)
D
1
Index
7
Area
E
H
0.070 (1,78)
0.045 (1,14)
0.195 (4,95)
0.325 (8,26)
Base Plane
0.115 (2,92)
0.300 (7,62)
0.015 (0,38)
0.210 (5,33)
MAX
MIN
C
– C –
C
0.150 (3,81)
0.115 (2,92)
0.300 (7,63)
E
0.005 (0,13)
0.100 (2,54)
0.022 (0,56)
0.014 (0,36)
0.008 (0,20)
D
MIN
Seating Plane
Full Lead
4 PL
C
0.060 (1,52)
0.000 (0,00)
0.014 (0,36)
0.010 (0,25)
0.430 (10,92)
M
C
MAX
F
F
4202489/A 03/01
NOTES: A. All linear dimensions are in inches (millimeters).
B. This drawing is subject to change without notice.
I. Distance between leads including dambar protrusions
to be 0.005 (0,13) minumum.
J. A visual index feature must be located within the
cross–hatched area.
K. For automatic insertion, any raised irregularity on the
top surface (step, mesa, etc.) shall be symmetrical
about the lateral and longitudinal package centerlines.
L. Falls within JEDEC MS-001-AA.
C. Dimensions are measured with the package
seated in JEDEC seating plane gauge GS-3.
D. Dimensions do not include mold flash or protrusions.
Mold flash or protrusions shall not exceed 0.010 (0,25).
E. Dimensions measured with the leads constrained to be
perpendicular to Datum C.
F. Dimensions are measured at the lead tips with the
leads unconstrained.
G. Pointed or rounded lead tips are preferred to ease
insertion.
H. Lead shoulder maximum dimension does not include
dambar protrusions. Dambar protrusions shall not exceed
0.010 (0,25).
1
POST OFFICE BOX 655303 • DALLAS, TEXAS 75265
TI [ TEXAS INSTRUMENTS ]
