73S1217F Data Sheet
DS_1217F_002
Protocol Mode Register (SPrtcol): 0xFE0D Å 0x03
This register determines the protocol to be use when communicating with the selected smart card. This
register should be updated as required when switching between smart card interfaces.
Table 92: The SPrtcol Register
MSB
SCISYN MOD9/8B SCESYN
LSB
0
TMODE CRCEN CRCMS RCVATR
Bit
Symbol
Function
Smart Card Internal Synchronous mode – Configures internal smart card
interface for synchronous mode. This mode routes the internal interface
buffers for RST, IO, C4, C8 to SCCtl register bits for direct firmware control.
CLK is generated by the ETU counter.
SPrtcol.7
SCISYN
Synchronous 8/9 bit mode select – For sync mode, in protocols with 9-bit
words, set this bit. The first eight bits read go into the RX FIFO and the
ninth bit read will be stored in the IO (or SIO) data bit of the SRXCtl
register.
SPrtcol.6
SPrtcol.5
MOD9/8B
SCESYN
Smart Card External Synchronous mode – Configures External Smart Card
interface for synchronous mode. This mode routes the external smart card
interface buffers for SIO to SCECtl register bits for direct firmware control.
SCLK is generated by the ETU counter.
SPrtcol.4
SPrtcol.3
0
Reserved bit, must always be set to 0.
Protocol mode select – 0: T=0, 1: T=1. Determines which smart card
protocol is to be used during message processing.
TMODE
CRC Enable – 1 = Enabled, 0 = Disabled. Enables the
checking/generation of CRC/LRC while in T=1 mode. Has no effect in T=0
mode. If enabled and a message is being transmitted to the smart card,
the CRC/LRC will be inserted into the message stream after the last TX
byte is transmitted to the smart card. If enabled, CRC/LRC will be checked
on incoming messages and the value made available to the firmware via
the CRC LS/MS registers.
SPrtcol.2
CRCEN
CRC Mode Select – 1 = CRC, 0 = LRC. Determines type of checking
algorithm to be used.
SPrtcol.1
SPrtcol.0
CRCMS
Receive ATR – 1 = Enable ATR timeout, 0 = Disable ATR timeout. Set by
RCVATR firmware after the smart card has been turned on and the hardware is
expecting ATR.
102
Rev. 1.2
TERIDIAN [ TERIDIAN SEMICONDUCTOR CORPORATION ]
