73K224BL
V.22bis, V.22, V.21, Bell 212A, 103
Single-Chip Modem w/ Integrated Hybrid
DATA SHEET
SPECIAL REGISTER
SR
D7
0
D6
D5
D4
0
D3
D2
D1
D0
0
ADDR
101
TXBAUD
CLOCK
RXUN-
DSCR
DATA
TXD
SOURCE
SIGNAL
QUALITY
LEVEL
SIGNAL
QUALITY
LEVEL
SELECT 1
SELECT 0
BIT
NAME
DESCRIPTION
Not used at this time. Only write zeros to these bits.
D7, D4, D0
D6
TXBAUD CLK TXBAUD clock is the transmit baud-synchronous clock that can be used to
synchronize the input of arbitrary quad/di-bit patterns. The rising edge of
TXBAUD signals the latching of a baud-worth of data internally. Synchronous
data to be entered via the TXDALT bit, CR3 bit D7, should have data transitions
that start 1/2 bit period delayed from the TXBAUD clock edges.
D5
RXUNDSCR
Data
This bit outputs the data received before going to the descrambler.
This is useful for sending special unscrambled patterns that can be used for
signaling.
D3
TXD Source
This bit selects the transmit data source; either the TXD pin if zero or the
TXDALT if this bit is a one. The transmit pattern bits D7 and D6 in CR1 override
either of these sources.
D2, D1
Signal Quality
Level Select
The signal quality indicator is a logical zero when the signal received is
acceptable for low error rate reception. It is determined by the value of the
mean squared error (MSE) calculated in the decision process when compared
to a given threshold. This threshold can be set to four levels of error rate. The
SQI bit will be low for good or average connections. As the error rate crosses
the threshold setting, the SQI bit will toggle at a 1.66 ms rate. Toggling will
continue until the error rate indicates that the data pump has lost convergence
and a retrain is required. At that point the SQI bit will be a one constantly. The
SQI bit and threshold selection are valid for QAM and DPSK only and indicates
typical error rate.
D2
0
D1
0
THRESHOLD VALUE
UNITS
BER (default)
BER
10-5
10-6
10-4
10-3
0
1
1
0
BER
1
1
BER
NOTE: This register is "mapped" and is accessed by setting CR2 bit D6 to a one and addressing CR3. This
register provides functions to the 73K224BL user that are not necessary in normal communications. Bits
D7-D4 are read only, while D3-D0 are read/write. To return to normal CR3 access, CR2 bit D6 must be
returned to a zero.
Page: 19 of 33
© 2005, 2008 TERIDIAN Semiconductor Corporation
Rev 7.1
TERIDIAN [ TERIDIAN SEMICONDUCTOR CORPORATION ]
