71M6513/71M6513H
3-Phase Energy Meter IC
A Maxim Integrated Products Brand
DATA SHEET
AUGUST 2011
71M6513
V3P3
V3P3
200Ω
R1
10Ω
RESETZ
DGND
R2
C1
Pushbutton
1nF
Figure 39: External Components for RESETZ
Connecting the V3 Pin
The following should be noted when connecting the V3 pin:
1) If the V3 pin is unused it should be left floating or terminated to the VREF pin.
2) If the V3 pin is used as a comparator input the digital input voltage applied to V3 should be limited to VBIAS ±0.9V.
3) If the V3 pin is used either as an auxiliary analog input, and temperature measurements are made and evaluated
using the alternate multiplexer cycle, the V3 input voltage range must be restricted to VBIAS ±0.9 V (i.e. 0.6 V to 2.4
V). Otherwise, the TEMP or V3 measurement could be inaccurate. This precaution is particularly important for
customers who are using the TEMP samples for temperature compensation, especially with the 71M6513H devices.
Connecting a Battery
Many meter manufacturers assemble the meter PCB with the 71M6513 IC and the other electronic components first and then
join the meter PCB with the meter enclosure, sensors and other main components separately at a later production step.
Typically, programming, final test (ATE), and calibration are performed after this second step.
The following production sequence is strongly recommended:
1) During PCB assembly, when adding/inserting the battery, the board supply voltage (V3P3A, V3P3D) should be active
(i.e. at 3.3 VDC), which can be achieved by briefly connecting the battery to V3P3A/V3P3D through a jumper wire.
After the battery is inserted with the board power active, the jumper wire should be removed.
2) The battery should then remain connected through factory test (ATE), time on the shelf and shipment.
In cases where it is not feasible to power V3P3A/V3P3D while inserting the battery, it is recommended to isolate the battery in
its holder using a removable piece of Kapton tape or other isolating material. This isolation should then be removed once the
meter is fully powered during the calibration and test process.
Page: 88 of 104
© 2005-2011 Teridian Semiconductor Corporation
TERIDIAN [ TERIDIAN SEMICONDUCTOR CORPORATION ]
