GUI Operation
www.ti.com
The communications with the µC section is achieved through a 4-wire cable soldered at the pads
accessible on the bottom layer of the PCB (Refer to Figure 12).
Figure 12. HDC1050EVM Pads for I2C and Supply of the Smaller Sensor Section
3
GUI Operation
The section describes how to use the GUI
3.1 Starting the GUI
Follow these steps to start the GUI:
1. Select the windows start menu
2. Select “All programs”
3. Select the “Texas Instruments” folder
4. Select the Sensing Solutions GUI
5. Click “Sensing Solutions GUI”
6. Splash screen will appear for at least two seconds.
•
Slower PC’s may show a blank splash screen without any texts for up to 20 seconds
10
HDC1050EVM User 's Guide
SNAU181A–June 2015–Revised June 2015
Submit Documentation Feedback
Copyright © 2015, Texas Instruments Incorporated
TAOS [ TEXAS ADVANCED OPTOELECTRONIC SOLUTIONS ]
