CC2430
Radio
:
CSMA/CA Strobe Processor
Write instruction to
RFST
no
All instructions
written?
yes
Setup CSPT, CSPX,
CSPY, CSPZ and
CSPCTRL registers
Start execution by
writing ISSTART to
RFST
SSTOP instruction,
end of program or
writing ISTOP to
RFST stops program
Figure 50: Running a CSP program
14.34.7 Instruction Set Summary
This section gives an overview of the
instruction set. This is intended as a summary
and definition of instruction opcodes. Refer to
section 14.34.8 for a description of each
instruction.
they are executed immediately. If the CSP is
already executing a program the current
instruction will be delayed until the Immediate
Strobe instruction has completed.
For undefined opcodes, the behavior of the
CSP is defined as a No Operation Strobe
Command (SNOP).
Each instruction consists of one byte which is
written to the RFSTregister to be stored in the
instruction memory.
The Immediate Strobe instructions (ISxxx) are
not used in
a
program. When these
instructions are written to the RFST register,
CC2430 Data Sheet (rev. 2.1) SWRS036F
Page 178 of 211