CC1110Fx / CC1111Fx
7.11 Control AC Characteristics
TA = 25 °C, VDD = 3.0 V if nothing else stated. All measurement results are obtained using the
CC1110EM reference designs ([1]).
Parameter
Min
Typ
Max
Unit
Condition/Note
System clock,
fSYSCLK
0.1875
26
27
MHz
CC1110Fx
High speed crystal oscillator used as source (X).
Calibrated HS RCOSC used as source (RC).
tSYSCLK= 1/ fSYSCLK
0.1875
13
13.5
Source:
X/RC
Min: fXOSC = 24 MHz, CLKCON.CLKSPD= 111/111
Typ: fXOSC = 26 MHz, CLKCON.CLKSPD= 000/001
Max: fXOSC = 27 MHz, CLKCON.CLKSPD= 000/001
0.1875
0.1875
24
12
24
12
MHz
CC1111Fx
High speed crystal oscillator used as source (X).
HS RCOSC used as source (RC).
Source:
Min:
X/RC
XOSC = 48 MHz, CLKCON.CLKSPD= 111/111
f
Typ/Max: fXOSC = 48 MHz, CLKCON.CLKSPD= 000/001
RESET_N low
width
250
ns
See item 1, Figure 4. This is the shortest pulse that is
guaranteed to be recognized as a reset pin request.
Note: Shorter pulses may be recognized but will not lead
to complete reset of all modules within the chip.
Interrupt pulse
width
tSYSCLK
See item 2, Figure 4. This is the shortest pulse that is
guaranteed to be recognized as an interrupt request. In
PM2/3 the internal synchronizers are bypassed so this
requirement does not apply in PM2/3.
Table 19: Control Inputs AC Characteristics
Figure 4: Control Inputs AC Characteristics
SWRS033E
Page 25 of 239