CC1110Fx / CC1111Fx
7.9 Analog Temperature Sensor
TA= 25 °C, VDD = 3.0V if nothing else stated. All measurement results are obtained using the
CC1110EM reference designs ([1]).
Parameter
Min
Typ
Max
Unit
Condition/Note
0.660
0.755
0.859
0.958
2.54
0
V
V
V
V
Output voltage at -40 °C
Output voltage at 0 °C
Output voltage at +40 °C
Output voltage at +80 °C
Temperature coefficient
mV/°C Fitted from -20 °C to +80 °C
Error in calculated
temperature, calibrated
-2 *
2 *
°C
From –20°C to +80°C when using 2.43 mV / °C, after 1-point
calibration at room temperature
* The indicated minimum and maximum error with 1-point
calibration is based on measured values for typical process
parameters
Current consumption
0.3
mA
increase when enabled
Table 17: Analog Temperature Sensor Parameters
7.10 7-12 bit ADC
TA = 25 °C, VDD = 3.0V if nothing else stated. The numbers given here are based on tests performed
in accordance with IEEE Std 1241-2000 [8]. The ADC data are from CC2430 characterization. As the
CC1110Fx/C1111Fx uses the same ADC, the numbers listed in Table 18 should be good indicators of the
performance to be expected from CC1110Fx and CC1111Fx. Note that these numbers will apply for 24
MHz operated systems (like CC1110Fx using a 24 MHz crystal or CC1111Fx using a 48 MHz crystal).
Performance will be slightly different for other crystal frequencies (e.g. 26 MHz and 27 MHz).
Parameter
Min
Typ
Max
Unit Condition/Note
Input voltage
0
0
0
VDD
VDD
VDD
V
V
V
VDD is voltage on AVDD pin (2.0 – 3.6 V)
External reference voltage
VDD is voltage on AVDD pin (2.0 – 3.6 V)
VDD is voltage on AVDD pin (2.0 – 3.6 V)
External reference voltage
differential
Input resistance, signal
197
Simulated using 4 MHz clock speed (see section
13.10.2.7)
kΩ
Full-Scale Signal4
ENOB4
2.97
5.7
V
Peak-to-peak, defines 0 dBFS
7-bits setting
bits
Single ended input
7.5
9-bits setting
9.3
10-bits setting
10.8
6.5
12-bits setting
ENOB4
bits
7-bits setting
Differential input
8.3
9-bits setting
10.0
11.5
0-20
10-bits setting
12-bits setting
Useful Power Bandwidth
THD4
kHz
7-bits setting, both single and differential
-Single ended input
-Differential input
-75.2
-86.6
dB
dB
12-bits setting, -6 dBFS
12-bits setting, -6 dBFS
4 Measured with 300 Hz Sine input and VDD as reference.
SWRS033E
Page 23 of 239