Electrical characteristics
STM8S207xx, STM8S208xx
Total current consumption in halt mode
Table 26. Total current consumption in halt mode at V = 5 V, T -40 to 85° C
DD
A
Symbol
Parameter
Conditions
Typ
Max
Unit
Flash in operating mode, HSI
clock after wakeup
63.5
IDD(H)
Supply current in halt mode
µA
Flash in powerdown mode, HSI
clock after wakeup
6.5
35
Table 27. Total current consumption in halt mode at V = 3.3 V
DD
Symbol
Parameter
Conditions
Typ
Unit
Flash in operating mode, HSI clock after
wakeup
61.5
IDD(H)
Supply current in halt mode
µA
Flash in powerdown mode, HSI clock after
wakeup
4.5
Low power mode wakeup times
Table 28. Wakeup times
Symbol
Parameter
Conditions
Typ
Max(1) Unit
See
note(2)
Wakeup time from wait
mode to run mode(3)
tWU(WFI)
f
CPU = fMASTER = 16 MHz.
0.56
1(6)
Flash in operating
mode(5)
2(6)
MVR voltage
regulator on(4)
Flash in
powerdown
3(6)
48(6)
50(6)
mode(5)
Wakeup time active halt
mode to run mode.(3)
HSI (after
wakeup)
µs
tWU(AH)
Flash in operating
mode(5)
MVR voltage
regulator off(4)
Flash in
powerdown
mode(5)
Flash in operating mode(5)
Flash in powerdown mode(5)
52
54
Wakeup time from halt
mode to run mode(3)
tWU(H)
1. Data guaranteed by design, not tested in production.
2. tWU(WFI) = 2 x 1/fmaster + 7 x 1/fCPU
3. Measured from interrupt event to interrupt vector fetch.
4. Configured by the REGAH bit in the CLK_ICKR register.
5. Configured by the AHALT bit in the FLASH_CR1 register.
6. Plus 1 LSI clock depending on synchronization.
62/103
Doc ID 14733 Rev 9