Electrical characteristics
Table 22.
Symbol
f
OSC_IN
R
F
C
STM32F103x8, STM32F103xB
HSE 4-16 MHz oscillator characteristics
(1) (2)
Parameter
Oscillator frequency
Feedback resistor
Recommended load capacitance
versus equivalent serial
resistance of the crystal (R
S
)
(3)
HSE driving current
Oscillator transconductance
R
S
= 30
V
DD
= 3.3 V, V
IN
= V
SS
with 30 pF load
Startup
V
DD
is stabilized
25
2
Conditions
Min
4
Typ
8
200
30
Max
16
Unit
MHz
k
pF
i
2
g
m
1
mA
mA/V
ms
t
SU(HSE(4)
startup time
2. Based on characterization, not tested in production.
1. Resonator characteristics given by the crystal/ceramic resonator manufacturer.
3. The relatively low value of the RF resistor offers a good protection against issues resulting from use in a
humid environment, due to the induced leakage and the bias condition change. However, it is
recommended to take this point into account if the MCU is used in tough humidity conditions.
4. t
SU(HSE)
is the startup time measured from the moment it is enabled (by software) to a stabilized 8 MHz
oscillation is reached. This value is measured for a standard crystal resonator and it can vary significantly
with the crystal manufacturer
For C
L1
and C
L2
, it is recommended to use high-quality external ceramic capacitors in the
5 pF to 25 pF range (typ.), designed for high-frequency applications, and selected to match
the requirements of the crystal or resonator (see
C
L1
and C
L2
are usually the
same size. The crystal manufacturer typically specifies a load capacitance which is the
series combination of C
L1
and C
L2
. PCB and MCU pin capacitance must be included (10 pF
can be used as a rough estimate of the combined pin and board capacitance) when sizing
C
L1
and C
L2
. Refer to the application note AN2867 “Oscillator design guide for ST
microcontrollers” available from the ST website www.st.com.
Figure 22. Typical application with an 8 MHz crystal
Resonator with
integrated capacitors
CL1
OSC_IN
8 MH z
resonator
REXT(1)
OSC_OU T
RF
Bias
controlled
gain
STM32F103xx
fHSE
CL2
ai14145
1. R
EXT
value depends on the crystal characteristics.
Low-speed external clock generated from a crystal/ceramic resonator
The low-speed external (LSE) clock can be supplied with a 32.768 kHz crystal/ceramic
resonator oscillator. All the information given in this paragraph are based on characterization
results obtained with typical external components specified in
In the application,
the resonator and the load capacitors have to be placed as close as possible to the oscillator
pins in order to minimize output distortion and startup stabilization time. Refer to the crystal
resonator manufacturer for more details on the resonator characteristics (frequency,
package, accuracy).
50/92
Doc ID 13587 Rev 11
STMICROELECTRONICS [ STMICROELECTRONICS ]
