M27C160
Table 5. AC Measurement Conditions
High Speed
Input Rise and Fall Times
Input Pulse Voltages
Input and Output Timing Ref. Voltages
≤
10ns
0 to 3V
1.5V
Standard
≤
20ns
0.4V to 2.4V
0.8V and 2V
Figure 5. AC Testing Input Output Waveform
Figure 6. AC Testing Load Circuit
1.3V
High Speed
3V
1.5V
0V
DEVICE
UNDER
TEST
2.0V
0.8V
AI01822
1N914
3.3kΩ
Standard
2.4V
OUT
CL
0.4V
CL = 30pF for High Speed
CL = 100pF for Standard
CL includes JIG capacitance
AI01823B
Table 6. Capacitance
(1)
(T
A
= 25 °C, f = 1 MHz)
Symbol
C
IN
C
OUT
Parameter
Input Capacitance (except BYTEV
PP
)
Input Capacitance (BYTEV
PP
)
Output Capacitance
Test Condition
V
IN
= 0V
V
IN
= 0V
V
OUT
= 0V
Min
Max
10
120
12
Unit
pF
pF
pF
Note: 1. Sampled only, not 100% tested.
DEVICE OPERATION
The operating modes of the M27C160 are listed in
the Operating Modes Table. A single power supply
is required in the read mode. All inputs are TTL
compatible except for V
PP
and 12V on A9 for the
Electronic Signature.
Read Mode
The M27C160 has two organisations, Word-wide
and Byte-wide. The organisation is selected by the
signal level on the BYTEV
PP
pin. When BYTEV
PP
is at V
IH
the Word-wide organisation is selected
and the Q15A–1 pin is used for Q15 Data Output.
When the BYTEV
PP
pin is at V
IL
the Byte-wide or-
ganisation is selected and the Q15A–1 pin is used
for the Address Input A–1. When the memory is
logically regarded as 16 bit wide, but read in the
Byte-wide organisation, then with A–1 at V
IL
the
lower 8 bits of the 16 bit data are selected and with
A–1 at V
IH
the upper 8 bits of the 16 bit data are
selected.
The M27C160 has two control functions, both of
which must be logically active in order to obtain
data at the outputs. In addition the Word-wide or
Byte- wide organisation must be selected.
Chip Enable (E) is the power control and should be
used for device selection. Output Enable (G) is the
output control and should be used to gate data to
the output pins independent of device selection.
Assuming that the addresses are stable, the ad-
dress access time (t
AVQV
) is equal to the delay
from E to output (t
ELQV
). Data is available at the
output after a delay of t
GLQV
from the falling edge
of G, assuming that E has been low and the ad-
dresses have been stable for at least t
AVQV
-t
GLQV
.
4/19
STMICROELECTRONICS [ STMICROELECTRONICS ]
