欢迎访问ic37.com |
会员登录 免费注册
发布采购

LAN9215I-MT 参数 Datasheet PDF下载

LAN9215I-MT图片预览
型号: LAN9215I-MT
PDF下载: 下载PDF文件 查看货源
内容描述: 高效的单芯片10/100以太网控制器与HP Auto-MDIX的和工业温度支持 [Highly Efficient Single-Chip 10/100 Ethernet Controller with HP Auto-MDIX and Industrial Temperature Support]
分类和应用: 外围集成电路数据传输控制器局域网以太网局域网(LAN)标准时钟
文件页数/大小: 134 页 / 1602 K
品牌: SMSC [ SMSC CORPORATION ]
 浏览型号LAN9215I-MT的Datasheet PDF文件第125页浏览型号LAN9215I-MT的Datasheet PDF文件第126页浏览型号LAN9215I-MT的Datasheet PDF文件第127页浏览型号LAN9215I-MT的Datasheet PDF文件第128页浏览型号LAN9215I-MT的Datasheet PDF文件第130页浏览型号LAN9215I-MT的Datasheet PDF文件第131页浏览型号LAN9215I-MT的Datasheet PDF文件第132页浏览型号LAN9215I-MT的Datasheet PDF文件第133页  
Highly Efficient Single-Chip 10/100 Ethernet Controller with HP Auto-MDIX and Industrial Temperature Support  
Datasheet  
Chapter 7 Operational Characteristics  
7.1  
Absolute Maximum Ratings*  
Supply Voltage ...................................................................................................................+3.3V +/- 10%  
Operating Temperature ...........................................................................................................-40 to 85°C  
Storage Temperature.........................................................................................................-65°C to 150°C  
Positive Voltage on any pin, with respect to Ground........................................................................ 5.5V  
Negative Voltage on any pin, with respect to Ground .....................................................................-0.3V  
Note: The maximum pin ratings do not apply to the following analog pins - ATEST, RBIAS, EXRES1,  
TPO +/-, TPI +/-  
* Stresses exceeding those listed above could cause permanent damage to the device. This is a stress  
rating only and functional operation of the device at any other condition above those indicated in the  
operation sections of this specification is not implied.  
Note: When powering this device from laboratory or system power supplies, it is important that the  
absolute maximum ratings not be exceeded or device failure can result. Some power supplies  
exhibit voltage spikes on their outputs when AC power is switched on or off. In addition, voltage  
transients on the AC power line may appear on the DC output. If this possibility exists, it is  
suggested that a clamp circuit be used.  
7.2  
Power Consumption (Device Only)  
This section provides typical power consumption values for the LAN9215I in various modes of  
operation. All of these values are preliminary. These measurements were taken under the following  
conditions:  
Temperature: ................................................................................................................................... +25°C  
Device VDD:................................................................................................................................... +3.30V  
Table 7.1 Power Consumption Device Only  
Total Power - Typical (mW)  
MODE  
10BASE-T Operation  
D0, 10BASE-T /w traffic  
D0, Idle  
282  
289  
177  
65  
D1, Idle  
D2, Energy Detect Power Down  
D2, General Power Down  
100BASE-TX Operation  
D0, 100BASE-TX /w traffic  
D0, Idle  
2
402  
439  
301  
D1, Idle  
SMSC LAN9215I  
129  
Revision 1.5 (07-18-06)  
DATASHEET  
 复制成功!