High Performance Two Port 10/100 Managed Ethernet Switch with 32-Bit Non-PCI CPU Interface
Datasheet
The LAN9312 can be programmed to strip padding from the end of a transmit packet in the event that
the end of the packet does not align with the host burst boundary. This feature is necessary when the
LAN9312 is operating in a system that always performs multi-word bursts. In such cases the LAN9312
must guarantee that it can accept data in multiples of the Burst length regardless of the actual packet
length. When configured to do so, the LAN9312 will accept extra data at the end of the packet and
will remove the extra padding before transmitting the packet. The LAN9312 automatically removes data
up to the boundary specified in the Buffer End Alignment field specified in each TX command.
The host can instruct the LAN9312 to issue an interrupt when the buffer has been fully loaded into the
TX FIFO contained in the LAN9312 and transmitted. This feature is enabled through the TX command
‘Interrupt on Completion’ field.
Upon completion of transmission, irrespective of success or failure, the status of the transmission is
written to the TX Status FIFO. TX status is available to the host and may be read using PIO operations.
An interrupt can be optionally enabled by the host to indicate the availability of a programmable
number TX status DWORDS.
Before writing the TX command and payload data to the TX FIFO, the host must check the available
TX FIFO space by performing a PIO read of the TX FIFO Information Register (TX_FIFO_INF). The
host must ensure that it does not overfill the TX FIFO or the TX Error (TXE) flag will be asserted.
The host proceeds to write the TX command by first writing TX command ‘A’, then TX command ‘B’.
After writing the command, the host can then move the payload data into the TX FIFO. TX status
DWORDs are stored in the TX Status FIFO to be read by the host at a later time upon completion of
the data transmission onto the wire.
Figure 9.3 Simplified Host TX Flow Diagram
SMSC LAN9312
123
Revision 1.2 (04-08-08)
DATASHEET
SMSC [ SMSC CORPORATION ]
