High Performance Two Port 10/100 Managed Ethernet Switch with 32-Bit Non-PCI CPU Interface
Datasheet
31
24 23
16 15
8 7
0
BCh
9Ah
06h
05h
04h
03h
02h
01h
00h
xx
HMAC_ADDRH / SWITCH_MAC_ADDRH
31 24 23 16 15 8 7
xx
BCh
9Ah
78h
56h
34h
0
12h
78h
56h
34h
12h
A5h
EEPROM
HMAC_ADDRL / SWITCH_MAC_ADDRL
Figure 9.2 Example EEPROM MAC Address Setup
Note: By convention, the right nibble of the left most byte of the Ethernet address (in this example,
the 2 of the 12h) is the most significant nibble and is transmitted/received first.
For more information on the EEPROM and EEPROM Loader, refer to Section 10.2, "I2C/Microwire
Master EEPROM Controller," on page 137.
9.7
FIFOs
The LAN9312 contains four host-accessible FIFOs (TX Status, RX Status, TX Data, and RX Data) and
two internal inaccessible Host MAC TX/RX MIL FIFO’s (TX MIL FIFO, RX MIL FIFO).
9.7.1
TX/RX FIFOs
The TX/RX Data and Status FIFOs store the incoming and outgoing address and data information,
acting as a conduit between the host bus interface (HBI) and the Host MAC. The sizes of these FIFOs
are configurable via the Hardware Configuration Register (HW_CFG) register to the ranges described
in Table 9.8. Refer to Section 9.7.3, "FIFO Memory Allocation Configuration" for additional information.
The the RX and TX FIFOs related register definitions can be found in section Section 14.2.2, "Host
MAC & FIFO’s".
The TX and RX Data FIFOs have the base address of 00h and 20h respectively. However, each FIFO
is also accessible at seven additional contiguous memory locations, as can be seen in Figure 14.1.
The Host may access the TX or RX Data FIFOs at any of these alias port locations, as they all function
identically and contain the same data. This alias port addressing is implemented to allow hosts to burst
through sequential addresses.
The TX and RX Status FIFOs can each be read from two register locations; the Status FIFO Port, and
the Status FIFO PEEK. The TX and RX Status FIFO Ports (48h and 40h respectively) will perform a
destructive read, popping the data from the TX or RX Status FIFO. The TX and RX Status FIFO PEEK
register locations (4Ch and 44h respectively) allow a non-destructive read of the top (oldest) location
of the FIFOs.
Proper use of the The TX/RX Data and Status FIFOs, including the correct data formatting is described
in detail in Section 9.8, "TX Data Path Operation," on page 122 and Section 9.9, "RX Data Path
Operation," on page 132.
9.7.2
MIL FIFOs
The MAC Interface Layer (MIL), within the Host MAC, contains a 2KB transmit and a 128 Byte receive
FIFO which are separate from the TX and RX FIFOs. These MIL FIFOs are not directly accessible
from the HBI. The differentiation between the TX/RX FIFOs and the TX/RX MIL FIFOs is that once the
transmit or receive packets are in the MIL FIFOs, the host no longer can control or access the TX or
Revision 1.2 (04-08-08)
120
SMSC LAN9312
DATASHEET
SMSC [ SMSC CORPORATION ]
