欢迎访问ic37.com |
会员登录 免费注册
发布采购

LAN91C111I-NE 参数 Datasheet PDF下载

LAN91C111I-NE图片预览
型号: LAN91C111I-NE
PDF下载: 下载PDF文件 查看货源
内容描述: 10/100非PCI以太网单芯片MAC + PHY [10/100 Non-PCI Ethernet Single Chip MAC + PHY]
分类和应用: PC以太网局域网(LAN)标准
文件页数/大小: 142 页 / 1664 K
品牌: SMSC [ SMSC CORPORATION ]
 浏览型号LAN91C111I-NE的Datasheet PDF文件第56页浏览型号LAN91C111I-NE的Datasheet PDF文件第57页浏览型号LAN91C111I-NE的Datasheet PDF文件第58页浏览型号LAN91C111I-NE的Datasheet PDF文件第59页浏览型号LAN91C111I-NE的Datasheet PDF文件第61页浏览型号LAN91C111I-NE的Datasheet PDF文件第62页浏览型号LAN91C111I-NE的Datasheet PDF文件第63页浏览型号LAN91C111I-NE的Datasheet PDF文件第64页  
10/100 Non-PCI Ethernet Single Chip MAC + PHY  
Datasheet  
ABORT_ENB - Enables abort of receive when collision occurs. Defaults low. When set, the  
LAN91C111 will automatically abort a packet being received when the appropriate collision input is  
activated. This bit has no effect if the SWFDUP bit in the TCR is set.  
STRIP_CRC - When set, it strips the CRC on received frames. As a result, both the Byte Count and  
the frame format do not contain the CRC. When clear, the CRC is stored in memory following the  
packet. Defaults low.  
RXEN - Enables the receiver when set. If cleared, completes receiving current frame and then goes  
idle. Defaults low on reset.  
ALMUL - When set accepts all multicast frames (frames in which the first bit of DA is '1'). When clear  
accepts only the multicast frames that match the multicast table setting. Defaults low.  
PRMS - Promiscuous mode. When set receives all frames. Does not receive its own transmission  
unless it is in Full Duplex!  
RX_ABORT - This bit is set if a receive frame was aborted due to length longer than 2K bytes. The  
frame will not be received. The bit is cleared by RESET or by the CPU writing it low.  
Reserved - Must be 0.  
8.8  
Bank 0 - Counter Register  
OFFSET  
6
NAME  
TYPE  
SYMBOL  
ECR  
COUNTER REGISTER  
READ ONLY  
Counts four parameters for MAC statistics. When any counter reaches 15 an interrupt is issued. All  
counters are cleared when reading the register and do not wrap around beyond 15.  
HIGH  
NUMBER OF EXC. DEFFERED TX  
NUMBER OF DEFFERED TX  
BYTE  
0
0
0
0
0
0
0
0
0
0
0
0
LOW  
MULTIPLE COLLISION COUNT  
SINGLE COLLISION COUNT  
BYTE  
0
0
0
0
Each four bit counter is incremented every time the corresponding event, as defined in the EPH  
STATUS REGISTER bit description, occurs. Note that the counters can only increment once per  
enqueued transmit packet, never faster, limiting the rate of interrupts that can be generated by the  
counters. For example if a packet is successfully transmitted after one collision the SINGLE  
COLLISION COUNT field is incremented by one. If a packet experiences between 2 to 16 collisions,  
the MULTIPLE COLLISION COUNT field is incremented by one. If a packet experiences deferral the  
NUMBER OF DEFERRED TX field is incremented by one, even if the packet experienced multiple  
deferrals during its collision retries.  
The COUNTER REGISTER facilitates maintaining statistics in the AUTO RELEASE mode where no  
transmit interrupts are generated on successful transmissions.  
Reading the register in the transmit service routine will be enough to maintain statistics.  
Revision 1.8 (07-13-05)  
SMSC LAN91C111-REV B  
DATA6S0HEET