Highly Efficient Single-Chip 10/100 Non-PCI Ethernet Controller
Datasheet
BITS
DESCRIPTION
TYPE
DEFAULT
15
Force RX Discard (RX_DUMP). This self-clearing bit clears the RX data
and status FIFOs of all pending data. When a ‘1’ is written, the RX data
and status pointers are cleared to zero.
SC
0
Note:
Please refer to section “Force Receiver Discard (Receiver
Dump)” on page 54 for a detailed description regarding the use
of RX_DUMP.
14-13
12-8
Reserved
RO
-
RX Data Offset (RXDOFF). This field controls the offset value, in bytes,
that is added to the beginning of an RX data packet. The start of the valid
data will be shifted by the number of bytes specified in this field. An offset
of 0-31 bytes is a valid number of offset bytes.
R/W
00000
Note:
The two LSBs of this field (D[9:8]) must not be modified while
the RX is running. The receiver must be halted, and all data
purged before these two bits can be modified. The upper three
bits (DWORD offset) may be modified while the receiver is
running. Modifications to the upper bits will take affect on the
next DWORD read.
7-0
Reserved
RO
-
Table 5.2 RX Alignment Bit Definitions
[31]
[30]
0
End Alignment
4-byte alignment
16-byte alignment
32-byte alignment
Reserved
0
0
1
1
1
0
1
5.3.8
TX_CFG—Transmit Configuration Register
Offset:
70h
Size:
32 bits
This register controls the transmit functions on the LAN9116 Ethernet Controller.
BITS
31-16
15
DESCRIPTION
Reserved.
TYPE
DEFAULT
RO
SC
-
Force TX Status Discard (TXS_DUMP). This self-clearing bit clears the TX
status FIFO of all pending status DWORD’s. When a ‘1’ is written, the TX
status pointers are cleared to zero.
0
14
Force TX Data Discard (TXD_DUMP). This self-clearing bit clears the TX
data FIFO of all pending data. When a ‘1’ is written, the TX data pointers
are cleared to zero.
SC
RO
0
13-3
Reserved
-
Revision 1.1 (05-17-05)
SMSC LAN9116
DATA7S4HEET
SMSC [ SMSC CORPORATION ]
