CONFIGURATION
The Configuration of the FDC37M60x is very
configuration ports to initialize the logical
devices at POST. The INDEX and DATA ports
are only valid when the FDC37M60x is in
Configuration Mode.
flexible and is based on the configuration
architecture implemented in typical Plug-and-
Play components. The FDC37M60x is designed
for motherboard applications in which the
resources required by their components are
known. With its flexible resource allocation
architecture, the FDC37M60x allows the BIOS to
assign resources at POST.
The SYSOPT pin is latched on the falling edge
of the RESET_DRV or on Vcc Power On Reset
to determine the configuration register's base
address. The SYSOPT pin is used to select the
CONFIG PORT's I/O address at power-up.
Once powered up the configuration port base
address can be changed through configuration
registers CR26 and CR27. The SYSOPT pin
is a hardware configuration pin which is
shared with the nRTS1 signal on pin 87.
During reset this pin is a weak active low signal
which sinks 30µA. Note: All I/O addresses are
qualified with AEN.
SYSTEM ELEMENTS
Primary Configuration Address Decoder
After a hard reset (RESET_DRV pin asserted) or
Vcc Power On Reset the FDC37M60x is in the
Run Mode with all logical devices disabled. The
logical devices may be configured through two
standard Configuration I/O Ports (INDEX and
DATA) by placing the FDC37M60x into
Configuration Mode. The BIOS uses these
The INDEX and DATA ports are effective only
when the chip is in the Configuration State.
SYSOPT= 0
SYSOPT= 1
(PULL-DOWN RESISTOR)
REFER TO NOTE 1
CONFIG PORT (Note 2) 0x03F0
(10K PULL-UP
RESISTOR)
0x0370
PORT NAME
TYPE
Write
INDEX PORT (Note 2)
DATA PORT
0x03F0
0x0370
Read/Write
Read/Write
INDEX PORT + 1
Note 1: If using TTL RS232 drivers use 1K pull-down. If using CMOS RS232 drivers use 10K
pull-down.
Note 2: The configuration port base address can be relocated through CR26 and CR27.
Entering the Configuration State
Exiting the Configuration State
The device enters the Configuration State when
the following Config Key is successfully written
to the CONFIG PORT.
The device exits the Configuration State when
the following Config Key is successfully written
to the CONFIG PORT.
Config Key = < 0x55 >
Config Key = < 0xAA>
122
SMSC [ SMSC CORPORATION ]
