1°C Multiple Temperature Sensor with HW Thermal Shutdown & Hottest of Thermal Zones
Datasheet
Chapter 6 Package Information
6.1
EMC1046/EMC1047 Package Drawing
REVISION HISTORY
DESCRIPTION
INITIAL RELEASE
REVISION
A
DATE
RELEASED BY
S.K.ILIEV
5
3
3/29/05
D
PIN 1 IDENTIFIER
AREA (D/2 X E1/2)
e
c
4
3
E1
E
SEE DETAIL "A"
END VIEW
4
2
10X b
TOP VIEW
A2
A
C
SEATING PLANE
A1
ccc
C
NOTES:
1. ALL DIMENSIONS ARE IN MILLIMETER.
2. TOLERANCE ON THE TRUE POSITION OF EACH LEAD IS ± 0.04 mm AT MAXIMUM MATERIAL
CONDITION.
SIDE VIEW
3-D VIEW
3. PACKAGE BODY DIMENSIONS "D" AND "E1" DO NOT INCLUDE MOLD/INTERLEAD PROTRUSIONS
OR FLASH. MAXIMUM MOLD PROTRUSIONS OR FLASH IS 0.15 mm (0.006 INCHES) PER END AND
SIDE. DIMENSIONS "D" AND "E1" ARE DETERMINED AT THE OUTERMOST EXTREMES OF THE
PLASTIC BODY, INCLUDING ANY MISMATCH BETWEEN TOP AND BOTTOM PLASTIC BODY. THEY
ARE DETERMINED AT DATUM PLANE "H".
H
4. DIMENSIONS "b" AND "c" APPLY TO THE FLAT SECTION OF THE LEAD BETWEEN 0.08 mm AND
0.15 mm FROM THE LEAD TIP.
5. DETAILS OF THE PIN 1 IDENTIFIER ARE OPTIONAL, BUT MUST BE LOCATED WITHIN THE ZONE
INDICATED.
C
GAUGE PLANE
0° - 8°
0.25
SEATING PLANE
THIRD ANGLE PROJECTION
UNLESS OTHERWISE SPECIFIED
DIMENSIONS ARE IN MILLIMETERS
AND TOLERANCES ARE:
L
80 ARKAY DRIVE
HAUPPAUGE, NY 11788
USA
DECIMAL
X.X ±0.1
ANGULAR
±1°
(0.95)
X.XX ±0.05
X.XXX ±0.025
TITLE
NAME
DATE
DIM AND TOL PER ASME Y14.5M
-
1994
PACKAGE OUTLINE
10 PIN TSSOP, 3x3 MM BODY, 0.50 MM PITCH
DETAIL "A"
MATERIAL
DRAWN
-
S.K.ILIEV
3/29/05
FINISH
CHECKED
DWG NUMBER
REV
-
S.K.ILIEV
3/29/05
3/29/05
A
MO-10-TSSOP-3x3
APPROVED
SCALE
STD COMPLIANCE
SHEET
PRINT WITH "SCALE TO FIT"
DO NOT SCALE DRAWING
S.K.ILIEV
1:1
JEDEC: MO-187
1 OF 1
Figure 6.1 10-Pin TSSOP Package Drawing
Revision 0.62 (03-05-08)
SMSC EMC1046/EMC1047
DATA3S6HEET
SMSC [ SMSC CORPORATION ]
