8 Channel Capacitive Touch Sensor with 8 LED Drivers
Datasheet
Chapter 2 Electrical Specifications
Table 2.1 Absolute Maximum Ratings
Voltage on 5V tolerant pins (V5VT_PIN
)
-0.3 to 5.5
0 to 3.6
V
V
V
V
W
Voltage on 5V tolerant pins (|V5VT_PIN - VDD|) Note 2.2
Voltage on VDD pin
-0.3 to 4
Voltage on any other pin to GND
-0.3 to VDD + 0.3
0.9
Package Power Dissipation up to TA = 85°C for 24 pin QFN
(see Note 2.3)
Junction to Ambient (θJA) (see Note 2.4)
Operating Ambient Temperature Range
Storage Temperature Range
58
°C/W
°C
-40 to 125
-55 to 150
8000
°C
ESD Rating, All Pins, HBM
V
Note 2.1 Stresses above those listed could cause permanent damage to the device. This is a stress
rating only and functional operation of the device at any other condition above those
indicated in the operation sections of this specification is not implied.
Note 2.2 For the 5V tolerant pins that have a pull-up resistor, the voltage difference between
V5VT_PIN and VDD must never exceed 3.6V.
Note 2.3 The Package Power Dissipation specification assumes a recommended thermal via design
consisting of a 3x3 matrix of 0.3mm (12mil) vias at 1.0mm pitch connected to the ground
plane with a 2.5 x 2.5mm thermal landing.
Note 2.4 Junction to Ambient (θJA) is dependent on the design of the thermal vias. Without thermal
vias and a thermal landing, the θJA is approximately 60°C/W including localized PCB
temperature increase.
Table 2.2 Electrical Specifications
VDD = 3V to 3.6V, TA = 0°C to 100°C, all Typical values at TA = 27°C unless otherwise noted.
CHARACTERISTIC
SYMBOL
MIN
TYP
MAX
UNIT
CONDITIONS
DC Power
3.3
Supply Voltage
VDD
3.0
3.6
V
SMSC CAP1088
Revision 1.1 (08-05-09)
DATAS11HEET
SMSC [ SMSC CORPORATION ]
