5 and 6 Channel Capacitive Touch Sensor
Datasheet
Chapter 7 Revision History
Table 7.1 Customer Revision History
REVISION LEVEL & DATE
SECTION/FIGURE/ENTRY
CORRECTION
Rev. 1.1 (08-05-09)
Features
“TBD” replaced with “3uA” under Low Power
Operation
General Description
Deep sleep drawing “5uA” of current changed to
“3uA”
Table 2.2, "Electrical
Specifications"
Table updated:
- Current Measurement, ISTBY - changed the
typical column to 160, max to 210. Changed the
conditions to read: " Standby state active, one
sensor monitored, default conditions (8 avg, 70ms
cycle time)"
- Current Measurement, IDSLEEP -changed the
TYP column value to 3 and max to 10.
Section 3.1.1, "SMBus (I2C)
Communications"
The following text deleted: “The SPI_CS# pin is not
used and any data presented to this pin will be
ignored.”
Section 6.2, "Package
Marking"
Updated package markings per new standards
Rev. 1.0 (06-16-09)
Document title modified;
reel size added to ordering information;
updates to pinout, general description and register set.
“System RESET pin” removed from features
Chapter 1, Pin Description
Pin tables modified adding SPI to “ALERT# /
BC_IRQ#” pin
Table 2.1, "Absolute
Maximum Ratings"
Notes following table modified
Figure 3.1, "SPI Timing"
Updated figure
Section 3.6, "BC-Link
Interface (CAP1006-2 only)"
Removed “8051” from 2nd paragraph
Chapter 4, General
Description
Second to last paragraph removed, not needed as
clarification follows
Section 4.1, "Power States"
Removed mention of LED driver outputs
Table 5.1, "Register Set in
Hexadecimal Order"
Updated text and register descriptions for incorrect
#’s Cap Sense channels
Section 6.2, "Package
Marking"
Updated package markings
Rev. 0.56 (5/1/09)
General
Fixed typos and updated text as necessary.
Cleaned up system diagrams
Section 5.5, "Sensitivity
Control Register"
Renamed bit fields
Revision 1.1 (08-05-09)
SMSC CAP1005 / CAP1006
DATA5S2HEET
SMSC [ SMSC CORPORATION ]
