C8051F360/1/2/3/4/5/6/7/8/9
Table 3.1. Global Electrical Characteristics (Continued)
–40 to +85 °C, 25 MHz system clock unless otherwise specified.
Parameter
Conditions
Min Typ Max
Units
Digital Supply Current—CPU Inactive (Idle Mode, not fetching instructions from Flash)
2
V
V
V
V
V
V
= 3.6 V, F = 100 MHz
= 3.6 V, F = 25 MHz
= 3.0 V, F = 100 MHz
= 3.0 V, F = 25 MHz
= 3.0 V, F = 1 MHz
= 3.0 V, F = 80 kHz
—
—
—
—
—
—
36
9
40
12
35
9
mA
mA
mA
mA
mA
µA
DD
DD
DD
DD
DD
DD
I
DD
30
7
0.24
19
—
—
3
F = 25 MHz
F = 1 MHz
—
—
—
44
—
—
—
%/V
%/V
I
I
Supply Sensitivity
DD
43.7
0.24
3,5
V
V
V
V
= 3.0 V, F <= 1 MHz, T = 25 °C
= 3.0 V, F > 1 MHz, T = 25 °C
= 3.6 V, F <= 1 MHz, T = 25 °C
= 3.6 V, F > 1 MHz, T = 25 °C
mA/MHz
DD
DD
DD
DD
Frequency Sensitivity
DD
—
—
—
—
0.25
0.31
0.32
< 0.1
—
—
—
—
mA/MHz
mA/MHz
mA/MHz
µA
Digital Supply Current
(Stop Mode, shutdown)
Oscillator not running,
Monitor Disabled
V
DD
Notes:
1. SYSCLK must be at least 32 kHz to enable debugging.
2. SYSCLK is the internal device clock. For operational speeds in excess of 30 MHz, SYSCLK must be derived
from the Phase-Locked Loop (PLL).
3. Based on device characterization data; Not production tested.
4. IDD can be estimated for frequencies < 20 MHz by simply multiplying the frequency of interest by the frequency
sensitivity number for that range. When using these numbers to estimate IDD for >20 MHz, the estimate should
be the current at 25 MHz minus the difference in current indicated by the frequency sensitivity number. For
example: VDD = 3.0 V; F = 20 MHz, IDD = 15.9 mA - (25 MHz - 20 MHz) * 0.38 mA/MHz = 14 mA.
5. Idle IDD can be estimated for frequencies < 1 MHz by simply multiplying the frequency of interest by the
frequency sensitivity number for that range. When using these numbers to estimate Idle IDD for >1 MHz, the
estimate should be the current at 25 MHz minus the difference in current indicated by the frequency sensitivity
number. For example: VDD = 3.0 V; F = 5 MHz, Idle IDD = 7.2 mA - (25 MHz - 5 MHz) * 0.25 mA/MHz = 2.2 mA.
Other electrical characteristics tables are found in the data sheet section corresponding to the associated
peripherals. For more information on electrical characteristics for a specific peripheral, refer to the page
indicated in Table 3.2.
34
Rev. 1.0
SILICON [ SILICON ]
