SHARP CORPORATION
1
i
November
28. 1995
1
1. Application
This specification
applies to the outline
Model No. PC8 17series.
and characteristics
of photocoupler
2. Outline
Refer to the attached
drawing
No. CY7073K02.
3. Ratings
and characteristics
sheet, page 3 to 6.
Refer to the attached
4. Reliability
Refer to the attached
sheet, page 7.
5. Incoming
inspection
sheet, page 8.
Refer to the attached
6. Supplement
6.1 Isolation
voltage shall be measured
in the following
method.
collector
(11 Short between anode to cathode on the primary
to emitter on the secondary side.
(21 The dielectric
withstand
tester with
zero-cross
side and between
circuit
shall be used.
(3) The wave form of applied voltage shall be a sine wave.
(It is recommended
that the isolation voltage be measured
in insulation
oil.)
SHARP [ SHARP ELECTRIONIC COMPONENTS ]
