GM5BW96385A
■ Label and Marking Information
Fig. 13 Label Contents
SHARP CORPORATION
Part number
Quantity
PART No.
GM5BW96385A
φ
φ
QUANTITY
2000
φ EIAJ C-3 Bar code
EIAJ C-3 Bar code
φ
LOT No. MI08A01 RANK
ޓ
ޛޓޓ
EIAJ C-3ޜ
MADE INޓ
PHILIPPINES
Indication (example) of lot number and rank
Indication (example) of production country
φ
φ
LOT Number
0 8
0 1
A
MI
1
2
3
4
Production plant code (alphabetically)
1
2
3
Production year (the last two digits of the year)
Production month
(alphabetically with January corresponding to A)
4 Production date (01 ~ 31)
: Chromaticity rank
Rank
GM5BW96385A-13
■ Design Notes
1. Do not allow the circuit design to apply any reverse voltage to the LED at any time, operating or not. Do not bias
this part in any manner when it is not operating.
2. This part can be easily damaged by external stress. Make sure they are not mechanically stressed during or
after assembly.
3. This product uses a blue LED chip in combination with fluorescent materials to achieve its color. There may be
some slight color change due to afterglow of the phosphor when driving this part with pulsed power.
4. This part has a high light output. Looking directly at it during full power output may cause injury.
5. Sharp recommends taking proper personal and environmental static control precautions when handling this part.
Static damage may affect this part’s reliability.
6. Materials of high thermal conductivity are incorporated in this device to allow generated heat to be effectively
transferred from it to the circuit board. For best reliability, Sharp recommends against locating other sources of
heat near the LED, and to design the circuit board in such a way that heat can easily escape from the circuit
board. Sharp also recommends designing the circuit board so that the part’s case temperature is always kept
under 100° (when the LED is turned on) including self-heating.
7. Sharp recommends handling these parts in a clean, non-dusty environment since surface dust may be difficult
to remove and can affect the optical performance of the part.
8. Sharp recommends confirming the part’s performance, reliability, and resistance to any of these conditions, if it
is to be used in any of these environments:
ꢀ Direct sunlight, outdoor exposure, dusty conditions
ꢀ In water, oil, medical fluids, and organic solvents
ꢀ Excessive moisture, such as dew or condensation
ꢀ Corrosive (salt) air or corrosive gases, such as Cl, H2S, NH3, SO2, NO±
Sheet No.: DG-0089001
11