Model No. GM2BB**QT1C
“Contents in this technical document be changed without any notice due to the product modification.”
http://www.sharp-world.com/products/device/
・ In the case of the handling withthe tweezers
In the case of the handling with the tweezers, please pick up the products with the sides of the
ꢀ
ceramic substrate and do not touch the lens portion .
・ In the case of the mount of the product
ꢀPlease use this productafter confirming the mounting condition,
because there is a possibility to have damage by the external stress
when the load is applied by the collet of the mounter.
Please see the recommended collet of this product as right picture.
1.66mm
1.2mm
2.6mm
3.2mm
⑨ Please make sure not to apply any external stress to resin after mounted as well.When the
substrate bends after mounted, the product might be applied by an external stress, and
thecrack will be generated in the soldering part.
Please arrange the product in the direction not stressed for thewarp of the substrate after
mounted.
⑩ Please do not pile the substrate after this product is mounted.This product will be damaged
by the substrate, and it causes the crack ofthe lens and not lighting bythe inner-wire
deformation or wiringdisconnection.
⑪ The products are not designed for the use under any of the following conditions. Please verify
their performance and reliability well enough if you use under any of the following conditions;
(1) In a place with a lot of moisture, dew condensation, briny air, and corrosive gas
(Cl, H2S, NH3, SO2, NOX, etc.)
(2) Under the direct sunlight, outdoor exposure, and in a dusty place
(3) In water, oil, medical fluid, and organic solvents
⑫ Guarantee covers the compliance to the quality standards mentioned in the Specifications;
however it does not cover the compatibility with application in the end-use, including assembly
and usage environment.
In case any quality problems occurred in the application of end-use, details will be separately
discussed and determined between the parties hereto.
18
sharp LD-E7-1-14-A
SHARP [ SHARP ELECTRIONIC COMPONENTS ]
