LC78622NE
22. Reset Circuit; Pin 58: RES
When power is first applied, this pin should be briefly set low and then set high. This will set the muting to –∞ dB
and stop the disk motor.
Constant linear velocity servo
Muting control
START
0 dB
BRAKE
CLV
STOP
–∞
Q subcode address conditions
Track jump mode
Address free
New
Address 1
Standard
Standard
Track count mode
Digital attenuator
New
DATA 00H to EEH
OFF
DATA 0
ON
OSC
Playback speed
Double speed
Normal speed
ON
Digital filter normal speed
OFF
Setting the RES pin low sets the LC78622NE to the settings enclosed in boxes in the table.
23. Other Pins; Pin 2:TAI, pin 64: TEST1, pin 11: TEST2, pin 32: TEST3, pin 33: TEST4, pin 62: TEST5, pin 59:
TST11
These pins are used for testing the LSI’s internal circuits. Even though pull-down resistors are built into the TAI and
TEST2 to TEST5 input pin circuits, these pins must be connected to 0 V during normal operation. TST11 is an output
pin and should normally be left open. Since TEST 1 is an input pin without a pull-down resistor built in, be sure to
connect to 0V.
No. 6015-23/31
SANYO [ SANYO SEMICON DEVICE ]
