ADSP-BF531/ADSP-BF532/ADSP-BF533
Each event type has an associated register to hold the return
address and an associated return-from-event instruction. When
an event is triggered, the state of the processor is saved on the
supervisor stack.
Table 3. System Interrupt Controller (SIC)
Peripheral Interrupt Event
PLL Wakeup
Default Mapping
IVG7
DMA Error
IVG7
The ADSP-BF531/ADSP-BF532/ADSP-BF533 processors’ event
controller consists of two stages, the core event controller (CEC)
and the system interrupt controller (SIC). The core event con-
troller works with the system interrupt controller to prioritize
and control all system events. Conceptually, interrupts from the
peripherals enter into the SIC, and are then routed directly into
the general-purpose interrupts of the CEC.
PPI Error
IVG7
SPORT 0 Error
IVG7
SPORT 1 Error
IVG7
SPI Error
IVG7
UART Error
IVG7
Real-Time Clock
IVG8
Core Event Controller (CEC)
DMA Channel 0 (PPI)
DMA Channel 1 (SPORT 0 Receive)
DMA Channel 2 (SPORT 0 Transmit)
DMA Channel 3 (SPORT 1 Receive)
DMA Channel 4 (SPORT 1 Transmit)
DMA Channel 5 (SPI)
DMA Channel 6 (UART Receive)
DMA Channel 7 (UART Transmit)
Timer 0
IVG8
The CEC supports nine general-purpose interrupts (IVG15–7),
in addition to the dedicated interrupt and exception events. Of
these general-purpose interrupts, the two lowest priority inter-
rupts (IVG15–14) are recommended to be reserved for software
interrupt handlers, leaving seven prioritized interrupt inputs to
support the peripherals of the processor. Table 2 describes the
inputs to the CEC, identifies their names in the event vector
table (EVT), and lists their priorities.
IVG9
IVG9
IVG9
IVG9
IVG10
IVG10
IVG10
IVG11
IVG11
IVG11
IVG12
IVG12
IVG13
IVG13
IVG13
Table 2. Core Event Controller (CEC)
Timer 1
Priority
Timer 2
(0 is Highest)
Event Class
Emulation/Test Control EMU
Reset RST
Nonmaskable Interrupt NMI
EVT Entry
Port F GPIO Interrupt A
Port F GPIO Interrupt B
Memory DMA Stream 0
Memory DMA Stream 1
Software Watchdog Timer
0
1
2
3
Exception
EVX
4
Reserved
5
Hardware Error
IVHW
IVTMR
IVG7
Event Control
6
Core Timer
The processors provide a very flexible mechanism to control the
processing of events. In the CEC, three registers are used to
coordinate and control events. Each register is 32 bits wide:
7
General Interrupt 7
General Interrupt 8
General Interrupt 9
General Interrupt 10
General Interrupt 11
General Interrupt 12
General Interrupt 13
General Interrupt 14
General Interrupt 15
8
IVG8
9
IVG9
• CEC interrupt latch register (ILAT) – The ILAT register
indicates when events have been latched. The appropriate
bit is set when the processor has latched the event and
cleared when the event has been accepted into the system.
This register is updated automatically by the controller, but
it can also be written to clear (cancel) latched events. This
register can be read while in supervisor mode and can only
be written while in supervisor mode when the correspond-
ing IMASK bit is cleared.
10
11
12
13
14
15
IVG10
IVG11
IVG12
IVG13
IVG14
IVG15
System Interrupt Controller (SIC)
• CEC interrupt mask register (IMASK) – The IMASK regis-
ter controls the masking and unmasking of individual
events. When a bit is set in the IMASK register, that event is
unmasked and is processed by the CEC when asserted. A
cleared bit in the IMASK register masks the event,
preventing the processor from servicing the event even
though the event may be latched in the ILAT register. This
register can be read or written while in supervisor mode.
Note that general-purpose interrupts can be globally
enabled and disabled with the STI and CLI instructions,
respectively.
The system interrupt controller provides the mapping and rout-
ing of events from the many peripheral interrupt sources to the
prioritized general-purpose interrupt inputs of the CEC.
Although the processors provide a default mapping, the user
can alter the mappings and priorities of interrupt events by writ-
ing the appropriate values into the interrupt assignment
registers (SIC_IARx). Table 3 describes the inputs into the SIC
and the default mappings into the CEC.
Rev. H
|
Page 7 of 64
|
January 2011
ROCHESTER [ Rochester Electronics ]
