PROTEXT - GSM REMOTE CONTROL
User Setup Commands cont...
PLEASE NOTE: ~ denotes a ‘space’ in the format of a message
Command
Description
Command Syntax
Example
This command sets an activation time of the relay
outputs. The default is to remain on following an ON
command and turn off following an OFF command.
Command:
Password123456~ODEL1~7
Output delay time
(ODEL)
<UNIT PW>~ODELn~t
If ‘t’ is set to a value from 1 to 9 then this sets the
number of seconds for which the output remains on
after an ON command. The OFF command is then
ignored. If ‘t’ is set to ‘0’, then the output returns
to default setting
n=Relay number
t=Delay time (seconds)
Response:
Identity7~ODEL1~7~OK
Combining Set-Up Commands into one SMS Text
In order to reduce the number of text messages to be sent when setting up, several commands may be combined together within a single Text
message sent to PROTEXT.
Any commands may be sent together, (the limit being that a text message can only be 160characters in total). Each command is separated by a
Commands Excluded from Multiple messages are : initial setting of password. Status Request
,
Command Syntax
<UNIT PW>~Command1, Command2, Command3, Command4,……..
Example In the following example the text message sends the following commands in one text, (the Password is ‘Password123456’)
ꢀ
ꢀ
Input Number3 to Text the number ‘01273 898000’
Output1 identity to be ‘Sprayer’
Text to be sent:
Response
< Password1234>~UID~<GATWICK>,~INUM3~<01273898000>, OSTRING1 Sprayer
GATWICK~INUM3~<01273898000>~OSTRING1~Sprayer
DS-PROTEXT-9
2009 REG No 277 4001, ENGLAND.
Page 14