欢迎访问ic37.com |
会员登录 免费注册
发布采购

FIREFLY-TX2 参数 Datasheet PDF下载

FIREFLY-TX2图片预览
型号: FIREFLY-TX2
PDF下载: 下载PDF文件 查看货源
内容描述: VIPER远程控制系统 [VIPER Remote Control Systems]
分类和应用: 远程控制
文件页数/大小: 6 页 / 1963 K
品牌: RFMD [ RF MICRO DEVICES ]
 浏览型号FIREFLY-TX2的Datasheet PDF文件第1页浏览型号FIREFLY-TX2的Datasheet PDF文件第2页浏览型号FIREFLY-TX2的Datasheet PDF文件第3页浏览型号FIREFLY-TX2的Datasheet PDF文件第5页浏览型号FIREFLY-TX2的Datasheet PDF文件第6页  
VIPER Remote Control Systems  
Pairing a Transmitter to a Receiver  
Each transmitter has a unique identity. Each time a transmitter Switch is operated, it emits a secure  
RF signal. The Receiver can learn this signal and allocate to any of its outputs.  
The only limitation is that each receiver has a maximum memory for upto 40 pairings, these can be from  
the same or any number of transmitters.  
Hint: the same transmitter may be taught to different receivers to create ‘master keys’.  
VIPER-S1 / VIPER-S2 / VIPER-S3 (12-30Vdc Receivers)  
To Learn a New Transmitter switch follow this procedure  
Any transmitter button can be learnt to one or many of the receiver output relays.  
Each button must be learnt to each relay individually by following this procedure:  
1.  
Select the receiver output relay to learn to:  
2.  
3.  
4.  
5.  
Briefly press the receiver Learn switch (S2) once  
The Learn LED will flash once to indicate output relay 1 is selected  
After the LED stops flashing, press the Learn switch again to select the next relay channel  
Repeat step 2 until the required output relay is selected.  
6.  
7.  
8.  
9.  
Press the button on the transmitter you want to learn to the relay output.  
The Learn LED will then illuminate, press the same transmitter button again.  
The Learn LED will then flash to indicate learning is complete.  
The transmitter button will now operate the relay.  
Erasing Receivers Memory  
1.  
Press and hold the receiver Learn Switch for approx 10 seconds.  
2.  
When the Learn LED turns OFF all memory is erased  
NOTE: You cannot erase individual Tx encoders  
Configuring Receiver Outputs  
The jumper links configure the outputs to be Momentary or Latching.  
The jumper links are made / removed by the small link ‘cap’ placed over the pin header.  
Link Positions  
Relay Outputs  
LK1  
LK2  
Closed  
Open  
RLY 1  
Mom  
Mom  
RLY 2  
RLY 3  
Mom  
RLY 4  
Mom  
Closed  
Closed  
Mom  
Mom  
Latch  
Latch  
Open  
Open  
Closed  
Open  
Mom  
Latch  
Latch  
Latch  
Latch  
Latch  
Latch  
Latch  
(The configuration shown in the picture above represents the third row of the table)  
DS VIPER-2  
©2009 REG No 277 4001, Lewes, England. Page 4