A-D CONVERTER
12.2 Block description
12.2.4 A-D conversion interrupt control register
Figure 12.2.7 shows the structure of the A-D conversion interrupt control register. For details about interrupts,
refer to “CHAPTER 6. INTERRUPTS.”
b7 b6 b5 b4 b3 b2 b1 b0
A-D conversion interrupt control register (Address 7016)
Function
Bit
0
Bit name
At reset R/W
b2 b1b0
Interrupt priority level select bits
0
RW
RW
RW
RW
0 0 0 : Level 0 (Interrupt disabled)
0 0 1 : Level 1
0 1 0 : Level 2
1
2
0
0
0 1 1 : Level 3
1 0 0 : Level 4
1 0 1 : Level 5
1 1 0 : Level 6
1 1 1 : Level 7
Interrupt request bit
Nothing is assigned.
Undefined
0 : No interrupt requested
1 : Interrupt requested
3
(Note 1) (Note 2)
7 to 4
Undefined
—
Notes 1: Before using an A-D conversion interrupt, be sure to clear this bit to “0” by software.
2: When writing to this bit, use the MOVM (MOVMB) or STA (STAB, STAD) instruction.
Fig. 12.2.7 Structure of A-D conversion interrupt control register
(1) Interrupt priority level select bits (bits 2 to 0)
These bits are used to select an A-D conversion interrupt’s priority level. When using an A-D conversion
interrupt, be sure to select one of the priority levels (1 to 7). When an A-D conversion interrupt
request occurs, its priority level is compared with the processor interrupt priority level (IPL). The
requested interrupt is enabled only when its priority level is higher than the IPL. (However, this
applies when the interrupt disable flag (I) = “0.”)
To disable an A-D conversion interrupt, set these bits to “000 ” (level 0).
2
(2) Interrupt request bit (bit 3)
This bit is set to “1” when an A-D conversion interrupt request has occurred. This bit is automatically
cleared to “0” when the A-D conversion interrupt request has accepted. This bit can be set to “1” or
cleared to “0” by software.
7906 Group User’s Manual Rev.2.0
12-10
RENESAS [ RENESAS TECHNOLOGY CORP ]
