THREE-PHASE WAVEFORM MODE
[Precautions for three-phase waveform mode]
[Precautions for three-phase waveform mode]
1. When using the three-phase waveform mode, be sure to fix the waveform output select bits (bits 2 to 0
at address A616) to “100
When not using the pulse output port mode and three-phase waveform mode, be sure to fix the waveform
output select bits (bits 2 through 0 at address A616) to “000 .”
2
,” and then, set the relevant registers.
2
2. When not inactivating the three-phase waveform output by using a falling edge input to pin P6OUTCUT
be sure to connect pin P6OUTCUT to Vcc via a resistor.
,
3. While the fixed level is output, be sure not to change the value of the U/V/W-phase fixed output’s polarity
set bit (bits 2 through 0 at address A916).
7906 Group User’s Manual Rev.2.0
10-36