Internet Data Sheet
HYB15T1G[40/80/16]0C2F
1-Gbit Double-Data-Rate-Two SDRAM
3.3
Extended Mode Register EMR(2)
The Extended Mode Registers EMR(2) and EMR(3) are reserved for future use and must be programmed when setting the
mode register during initialization.
%$ꢆ %$ꢃ %$ꢀ $ꢃꢅ $ꢃꢆ $ꢃꢃ $ꢃꢀ
$ꢇ
$ꢊ
$ꢁ
$ꢈ
$ꢂ
ꢀ
$ꢉ
$ꢅ
$ꢆ
$ꢃ
$ꢀ
ꢀ
ꢃ
ꢀ
ꢀ
65)
'&&
3$65
UHJꢌꢋDGGU
03%7ꢀꢂꢆꢀ
TABLE 12
EMR(2) Programming Extended Mode Register Definition, BA2:0=010B
Field Bits
Type1)
Description
BA2
16
w
Bank Address
0B
BA2 Bank Address
BA
[15:14]
w
Bank Adress
00B BA MRS
01B BA EMRS(1)
10B BA EMRS(2)
11B BA EMRS(3): Reserved
A
[13:8]
7
w
w
Address Bus
000000B A Address bits
SRF
Address Bus, High Temperature Self Refresh Rate for TCASE > 85°C
0B
1B
A7 disable
A7 enable 2)
A
[6:4]
3
w
w
Address Bus
000B A Address bits
DCC
Address Bus, Duty Cycle Correction (DCC)
0B
1B
A3 DCC disabled
A3 DCC enabled
Partial Self Refresh for 8 banks
PASR [2:0]
w
Address Bus, Partial Array Self Refresh for 8 Banks3)
Note: Only for 1G and 2G components
000B PASR0 Full Array
001B PASR1 Half Array (BA[2:0]=000, 001, 010 & 011)
010B PASR2 Quarter Array (BA[2:0]=000, 001)
011B PASR3 1/8 array (BA[2:0] = 000)
100B PASR4 3/4 array (BA[2:0]= 010, 011, 100, 101, 110 & 111)
101B PASR5 Half array (BA[2:0]=100, 101, 110 & 111)
110B PASR6 Quarter array (BA[2:0]= 110 & 111)
111B PASR7 1/8 array(BA[2:0]=111)
1) w = write only
2) When DRAM is operated at 85°C ≤ TCase ≤ 95°C the extended self refresh rate must be enabled by setting bit A7 to 1 before the self refresh
mode can be entered.
3) If PASR (Partial Array Self Refresh) is enabled, data located in areas of the array beyond the specified location will be lost if self refresh
is entered. Data integrity will be maintained if tREF conditions are met and no Self Refresh command is issued.
Rev. 1.00, 2008-08
22
11202007-1NZ2-6U4E
QIMONDA [ QIMONDA AG ]
