RELEASED
PM7380 FREEDM-32P672
DATA SHEET
PMC-1990262
ISSUE 5
FRAME ENGINE AND DATA LINK MANAGER 32P672
FBTBEN:
As a master, the GPIC does not generate fast back-to-back cycles to different
devices. This bit is forced low.
The upper 16-bits make up the PCI Status field. The status field tracks the
status of PCI bus related events. Reads to this register behave normally. Writes
are slightly different in that bits can be reset, but not set. A bit is reset whenever
the register is written, and the data in the corresponding bit location is a one.
66MHZ_CAPABLE:
The 66 MHz Capable bit is hardwired to one to indicate the GPIC is capable
of operating in 66 MHz mode.
FBTBE:
The FBTBE bit is hardwired to one to indicate the GPIC supports fast back-
to-back transactions with other targets.
DPR:
The Data Parity Reported (DPR) bit is set high if the GPIC is an initiator and
asserts or detects a parity error on the PERRB signal while the PERREN bit
is set in the Command register. The DPR bit is cleared by the PCI Host.
DVSLT[1:0]:
The Device Select Timing (DEVSLT) bits specify the allowable timings for the
assertion of DEVSELB by the GPIC as a target. These are encoded as 00B
for fast, 01B for medium, 10B for slow and 11B is not used. The GPIC allows
for medium timing.
TABT:
The Target Abort (TABT) bit is set high by the GPIC when as a target, it
terminates a transaction with a target abort. The TABT bit is cleared by the
PCI Host.
RTABT:
The Received Target Abort (RTABT) bit is set high by the GPIC when as an
initiator, its transaction is terminated by a target abort. The RTABT bit is
cleared by the PCI Host.
MABT:
The Master Abort (MABT) bit is set high by the GPIC when as an initiator, its
transaction is terminated by a master abort and a special cycle was not in
progress. The MABT bit is cleared by the PCI Host.
PROPRIETARY AND CONFIDENTIAL TO PMC-SIERRA,INC., AND FOR ITS CUSTOMERS’ INTERNAL USE
256
PMC [ PMC-SIERRA, INC ]
