RELEASED
PM7380 FREEDM-32P672
DATA SHEET
PMC-1990262
ISSUE 5
FRAME ENGINE AND DATA LINK MANAGER 32P672
FPTR[10:0]:
The indirect FIFO block pointer (FPTR[10:0]) identifies one of the blocks of
the circular linked list in the partial packet buffer used in the logical FIFO of
the current channel. The FIFO pointer to be written to the channel provision
RAM, in an indirect write operation, must be set up in this register before
triggering the write. The FIFO pointer value can be any one of the blocks
provisioned to form the circular buffer.
Reserved:
The reserved bit must be set low for correct operation of the FREEDM-
32P672 device.
TAVAIL:
The indirect transaction available bit (TAVAIL) reports the fill level of the
partial packet buffer used in the logical FIFO of the current channel. TAVAIL
is set high when the FIFO of the current channel contains sufficient data, as
controlled by XFER[3:0], to request a DMA transfer to the host memory.
TAVAIL is set low when the amount of receive data is too small to require a
transfer to host memory. TAVAIL is updated by an indirect channel read
operation.
DELIN:
The indirect delineate enable bit (DELIN) configures the HDLC processor to
perform flag sequence delineation and bit de-stuffing on the incoming data
stream. The delineate enable bit to be written to the channel provision RAM,
in an indirect channel write operation, must be set up in this register before
triggering the write. When DELIN is set high, flag sequence delineation and
bit de-stuffing is performed on the incoming data stream. When DELIN is set
low, the HDLC processor does not perform any processing (flag sequence
delineation, bit de-stuffing nor CRC verification) on the incoming stream.
DELIN reflects the value written until the completion of a subsequent indirect
channel read operation.
STRIP:
The indirect frame check sequence discard bit (STRIP) configures the HDLC
processor to remove the CRC from the incoming frame when writing the data
to the channel FIFO. The FCS discard bit to be written to the channel
provision RAM, in an indirect channel write operation, must be set up in this
register before triggering the write. When STRIP is set high and CRC[1:0] is
not equal to "00", the received CRC value is not written to the FIFO. When
STRIP is set low, the received CRC value is written to the FIFO. The bytes in
buffer field of the RPD correctly reflect the presence/absence of CRC bytes in
the buffer. The value of STRIP is ignored when DELIN is low. STRIP reflects
PROPRIETARY AND CONFIDENTIAL TO PMC-SIERRA,INC., AND FOR ITS CUSTOMERS’ INTERNAL USE
136
PMC [ PMC-SIERRA, INC ]
