Philips Semiconductors
Product specification
Stereo BTL audio output amplifier with DC
volume control
TDA7053A
MBG666
MBG665
30
2.0
handbook, halfpage
handbook, halfpage
I
VC
V
in
(µA)
(V)
20
1.6
10
0
1.2
0.8
−10
−20
0.4
−30
0
0
0
0.4
0.8
1.2
1.6
V
2.0
(V)
4
8
12
16
20
V
(V)
P
VC
THD = 1 %.
Fig.12 Volume control current as a function of
volume control voltage.
Fig.11 Input signal handling.
The maximum input signal voltage is measured at
THD = 1% at the output with a voltage gain of 0 dB.
APPLICATION INFORMATION
The application diagram is illustrated in Fig.13.
To avoid instabilities and too high distortion, the input
ground and power ground must be separated as far as
possible and connected as close as possible to the IC.
Test conditions
Tamb = 25 °C unless otherwise specified; VP = 6 V;
The DC volume control can be applied in several ways.
Two possible circuits are shown below the main
application diagram. The circuits at the control pin will
influence the switch-on and switch-off behaviour and the
maximum voltage gain.
V
DC = 1.4 V; fi = 1 kHz; RL = 8 Ω.
The quiescent current has been measured without load
impedance.
The output power as a function of the supply voltage has
been measured at THD = 10%. The maximum output
power is limited by the maximum power dissipation and the
maximum available output current.
For single-end applications the output peak current must
not exceed 100 mA. At higher output currents the
short-circuit protection (MCL) will be active.
1997 Jul 15
9
NXP [ NXP ]
