PI5A4684
Chip Scale Packaging,
Dual SPDT Analog Switch
(3)
Absolute Maximum Ratings(1)
Recommended Operating Conditions
Supply Voltage V
DC Switch Voltage (V ) ........................–0.5V to V +0.5V
DC Input Voltage (V ) ................................ –0.5V to +7.0V
Continuous Current NO_NC_COM_ .............................. ±500mA
Peak Current NO_NC_COM_
............................................ –0.5V to +7V
CC
Supply Voltage Operating (V ) . . . . . . . . . . . . 1.65V to 5.5V
CC
(2)
S
CC
Control Input Voltage (V ) . . . . . . . . . . . . . . . . . . . 0V to V
IN
CC
CC
CC
(2)
IN
Switch Input Voltage (V ). . . . . . . . . . . . . . . . . . . . 0V to V
IN
Output Voltage (V
) . . . . . . . . . . . . . . . . . . . . . . . 0V to V
OUT
Operating Temperature (T ) . . . . . . . . . . . . . . . –40°C to +85°C
A
(pulsed at 1ms 50% duty cycle) ............................... ±650mA
Input Rise and Fall Time (t ,t )
r f
Peak Current NO_NC_COM_
Control Input V = 2.3V - 3.6V. . . . . . . . . 0ns/V to 10ns/V
CC
(pulsed at 1ms 10% duty cycle) ............................... ±800mA
Control Input V = 4.5V - 5.5V. . . . . . . . . . 0ns/V to 5ns/V
CC
Thermal Resistance (θ ) . . . . . . . . . . . . . . . . . . . . . . 350°C/W
JA
Storage Temperature Range (T ) .............. –65°C to +150°C
STG
Junction Temperature under Bias (T ) .............................150°C
Lead Temperature (soldering 10s) . . . . . . . . . . . . . . . . . +300°C
J
Junction Lead Temperature (T )
L
Bump Temperature (soldering notes)
(Soldering, 10 seconds) ................................................260°C
Infared (15s). . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . +220°C
Vapor Phase (60ns) . . . . . . . . . . . . . . . . . . . . . . . . . . +215°C
Power Dissipation (P ) @ +85°C .................................. 250mW
D
Notes:
1. "Absolute Maximum Ratings” may cause permanent damage to the device. This is a stress only rating and operation of the device at these or any
other conditions beyond those indicated in the operational sections of this specification is not implied.
2. The input and output negative voltage ratings may be exceeded if the inut and output diode current ratings are observed.
3. Control input must be held HIGH or LOW; it must not float.
2
PS8792B
05/09/06
06-0062
PERICOM [ PERICOM SEMICONDUCTOR CORPORATION ]
