5.0 mm INFRARED EMITTING DIODE
L515EIR1C
REV:A / 1
yCHEMICAL RESISTANCE
1) Avoid exposure to chemicals as it may attack the LED surface and cause discoloration.
2) When washing is required, refer to the following table for the proper chemical to be used.
(Immersion time: within 3 minutes at room temperature.)
SOLVENT
Freon TE
Chlorothene
Isopropyl Alcohol
Thinner
ADAPTABILITY
NOTE: Influences of ultrasonic cleaning of the LED
resin body differ depending on factors such
as the oscillator output, size of the PC board
⊙
╳
⊙
╳
╳
╳
and the way in which the LED is mounted.
Therefore, ultrasonic cleaning should only be
performed by confirming an ultrasonic
cleaning trial run.
Acetone
Trichloroethylene
⊙--Usable ╳--Do not use.
yOTHER CONSIDERTIONS
1) Care must be taken to ensure that the reverse voltage will not exceed the absolute maximum
rating when using the LEDs with matrix drive.
2) The LEDs described in this data sheet are intended to be used for ordinary electronic
equipment (such as office equipment, communications equipment, measurement
instruments and household appliances). Consult PARA’s sales staff in advance for
information on the applications in which exceptional quality and reliability are required ,
particularly when the failure or malfunction of the LEDs may directly jeopardize life or health
(such as for airplanes, spacecraft, automobiles, traffic control equipment etc).
3) The formal specifications must be exchanged and signed by both parties before large volume
purchase begins.
DRAWING NO. : DS-23-09-0069
DATE : 2009-08-10
Page :11
PARALIGHT [ PARA LIGHT ELECTRONICS CO., LTD. ]
