Release by
PARALIGHT DCC
SURFACE MOUNT DEVICE LED
Part No.: L-C155TBJSCT-5A
REV:A/0
ꢀ
Bin Code List
ꢀ CAUTIONS
1.Application Limitation:
The LED’s described here are intended to be used for ordinary electronic equipment (such as office equipment,
communication equipment and household application). Consult PARA’s sales in advance for information on application
in which exceptional quality and reliability are required, particularly when the failure or malfunction of the LED’s may
directly jeopardize life or health (such as airplanes, automobiles, traffic control equipment, life support system and
safety devices).
2.Storage:
Before opening the package:
The LEDs should be kept at 5°C to 30°C or less and 85%RH or less. The LEDs should be used within a year.
After opening the package:
The LEDs should be kept at 5°C to 30°C or less and 70%RH or less. The LEDs should be soldered within 168 hours (7
days) after opening the package.
Please avoid rapid transitions in ambient temperature in high humidity environments where condensation may occur.
3.Soldering
Do not apply any stress to the lead frame during soldering while the LED is at high temperature.
Recommended soldering condition.
Reflow Soldering:
Pre-heat 120~150°C, 120sec. MAX., Peak temperature : 240°C Max. Soldering time: 10 sec Max.
Soldering Iron: (Not recommended)
Temperature 300°C Max., Soldering time : 3 sec. Max.(one time only), power dissipation of iron : 20W Max. use SN60
solder of solder with silver content and don’t to touch LED lens when soldering.
DATE:
PAGE
2009-06-30
DRAWING NO.: DS-31-09-XXXX
11of 13
PARA-FOR-068
PARALIGHT [ PARA LIGHT ELECTRONICS CO., LTD. ]
