After
Figure 3
Step 5: Drop the iBright™ E48i into the fluorescent luminaire. Switch main power on to light it up.
Retrofit Luminaire with Magnetic Ballast
Before
Figure 4
Installation Steps
Step 1: Turn off main power before installation
For safety, make sure the main power source is switched off before attempting to install.
Step 2: Remove existing fluorescent light.
The existing fluorescent light is not needed and should be recycled as appropriate.
Step 3: Open the ballast cover, disconnect all wires from the ballast, and disconnect the starter from the T8 sockets as shown in Figure 5
below. Remove the ballast from the fluorescent luminaire and recycle it as appropriate. Keep the starter in position. Keep one wire from each
socket to connect to the external power supply. The other wire should be cut off at the socket.
www.atgelectronics.com Toll free: 877-461-5333