Retrofit Luminaire with Electronic Ballast
Before
Figure 1
Installation Steps
Step 1: Turn off main power before installation
For safety, make sure main power source is switched off before attempting to install.
Step 2: Remove existing fluorescent light.
The existing fluorescent light is not needed and should be recycled as appropriate.
Step 3: Open the ballast cover, disconnect all power wires from the ballast, and take the ballast out of the fluorescent luminaire, as shown in
Figure 2 below.
Keep one wire from each socket to connect to the external power supply. The other wire should be cut off at the socket.
Figure 2
Step 4: Install the MATCHING external power supply, as shown in Figure 3 below.
The external power supply is sized to match the luminaire and should be installed near the middle of the luminaire using the 3M tape and
screws provided.
Connect the input wires of the external power supply to the main power outlet.
Using wire nuts, connect the output wires of the external power supply to one wire at both of the T8 sockets.
Place the existing cover back to protect the external power supply.
www.atgelectronics.com Toll free: 877-461-5333