E2E
E2E-X@T1 AC/DC 2-Wire Models
Size
Shielded
Item
Sensing distance
Set distance
Differential travel
Detectable object
Standard sensing object
Response
frequency
*1
DC
AC
Model
3 mm
±10%
0 to 2.4 mm
10% max. of sensing distance
Ferrous metal (The sensing distance decreases with non-ferrous metal. Refer to
Engineering Data
on page 18.)
Iron, 12
×
12
×
1 mm
1 kHz
25 Hz
Iron, 18
×
18
×
1 mm
0.5 kHz
Iron, 30
×
30
×
1 mm
0.4 kHz
E2E-X3T1
7 mm
±10%
0 to 5.6 mm
M12
M18
Shielded
E2E-X7T1
0 to 8 mm
E2E-X10T1
10 mm
±10%
M30
Power supply voltage
24 to 240 VDC (20 to 264 VDC)
(operating voltage range)
*2
48 to 240 VAC (40 to 264 VAC)
Leakage current
Load
current
Residual
voltage
DC: 1 mA max.
AC: 2 mA max.
5 to 100 mA
DC: 6 V max. (Load current: 100 mA, Cable length: 2 m)
AC: 10 V max. (Load current: 5 mA, Cable length: 2 m)
Operation indicator (red), Setting indicator (green)
NO (Refer to the timing charts under
I/O Circuit Diagrams
on page 21 for details.)
Load short-circuit protection (20 to 40 VDC only), Surge suppressor
Operating/Storage: 35% to 95% (with no condensation)
±10%
max. of sensing distance at 23°C in the temperature range of
−25
to 70°C
±1%
max. of sensing distance at rated voltage in the rated voltage
±15%
range
50 MΩ min. (at 500 VDC) between current-carrying parts and case
4,000 VAC, 50/60 Hz for 1 minute between current-carrying parts and case
Destruction: 10 to 55 Hz, 1.5-mm double amplitude for 2 hours each in X, Y, and Z directions
Destruction: 1,000 m/s
2
10 times each in X, Y, and Z directions
IEC 60529 IP67, in-house standards: oil-resistant
Pre-wired Models (Standard cable length: 2 m)
Approx. 80 g
Nickel-plated brass
PBT
Nickel-plated brass
Zinc-plated iron
Instruction manual
Approx. 140 g
Approx. 190 g
Control
output
Indicators
Operation mode
(with sensing object
approaching)
Protection circuits
Ambient humidity range
Temperature influence
Voltage influence
Insulation resistance
Dielectric strength
Vibration resistance
Shock resistance
Degree of protection
Connection method
Weight (packed state)
Case
Sensing
surface
Materials
Clamping
nuts
Toothed
washer
Accessories
Ambient temperature range
Operating:
−25
to 70°C, Storage:
−40
to 85°C (with no icing or condensation)
*1. The response frequency is an average value. Measurement conditions are as follows: standard sensing object, a distance of twice the standard sensing object, and
a set distance of half the sensing distance.
*2. Power Supply Voltage Waveform:
Use a sine wave for the power supply. Using a rectangular AC power supply may result in faulty reset.
15
OMRON [ OMRON ELECTRONICS LLC ]
