CP1E-E@@D@-@ CP1E-N@@D@-@/NA20D@-@
Connecting to Support Software
Operating Environment and System Configuration
The following system is required to operate the CX-Programmer. Make sure your system provides the following conditions and has the necessary
components.
Item
Description
Supported computer
IBM PC/AT or equivalent
CD-ROM or DVD-ROM drive One or more
Windows 2000 (Service Pack 4 or higher), XP, Vista, or 7
(except 64-bit edition)
Supported Operating Systems
CPU
Pentium II 333 MHz or faster
RAM
256 MB min. 512 MB or more recommended
600 MB min.
Available hard disk space
Display
800 x 600 SVGA min.
PLC and connection port
USB port, RS-232C port, RS-422A/485 port or Ethernet port
Connecting Methods
Using commercially available USB cable, connect the CX-Programmer to the peripheral USB port on the CPU Unit.
Host link connection can be made with RS-232C port to connect the Programming Device (CX-Programmer).
CX-Programmer
USB port
A connector
CP1E CPU Unit
Commercially available
USB cable
B connector
Peripheral USB port
(Conforming to USB 2.0, B connector)
Connecting Cable
Use the following cable to connect the CP1E CPU Unit to the computer running the Support Software.
USB port
Network type
(communications mode)
Port at Unit
Port at computer
Model numbers
Length
Peripheral USB port
(Conforming to USB 2.0, B connector)
Commercially available USB cable
(A connector - B connector)
USB port
USB 2.0 (or 1.1)
Less than 5 m
RS-232C Port for N/NA-type CPU Units
Connecting Cable
Port at Unit
Port at computer
Communications mode
Model
Length
Remarks
With anti-static
connectors
XW2Z-200S-CV
2m
RS-232C Port or
CP1W-CIF01
(Add this to the option board slot.)
With anti-static
connectors
Host Link
(SYSWAY)
XW2Z-500S-CV
5m
RS-232C port *
XW2Z-200S-V
XW2Z-500S-V
2m
5m
---
---
Note: Connectable with CX-Programmer Ver.9.1 or higher only.
* Use the USB-Serial Conversion Cable CS1W-CIF31 together to connect a PLC to a personal computer's USB port.
33
OMRON [ OMRON ELECTRONICS LLC ]
